West Elm Antler Wall Shelf Assembly Instruction

NOTE:

• For your safety, installation by two people is recommended.

• Maximum load on shelf is 40 lbs

• Wipe with a soft, dry cloth. To protect the nish, avoid

the use of all chemicals and household cleaners.

: antler wall shelf

mounting instructions

A

drywall toggle anchor 2x

B

Flush with wall

A

B

Screw head 1/4”
out from wall

A

B

screw 2x

C

paper template 1x

1.

Tape the enclosed template to the wall at the desired location.
Use a carpenter’s level to insure the lines of the template are
level. With a tack or nail, poke through the template into the
wall at the cross-marks. These holes will be the insertion points
for the hardware. Remove the template.

2. Using a Philip's head screwdriver, insert the drywall anchors (A)
into the wall at the insertion points. Press and turn clockwise
until anchors are ush with the wall.

5626536 - 02/08

3. Insert screws (B) into the anchors or at the insertion points, leaving
approximately 1/4" between the back of the screw head and the wall.

4. Align keyhole notches over the screw heads.

5. Slide the shelf down until it rests on the screws. Tighten or loosen
screws as needed to t the shelf snugly against the wall.

page 1 of 1