West Elm Angled-Leg Side Table Assembly Instruction

angled leg side table
! Tools supplied:
! Do not throw away packaging materials until assembly is complete.
! Assemble this item on a soft surface, such as cardboard or carpet, to protect fi nish.
! Proper assembly of this item requires 2 people.
assembly instructions
Parts
Hardware
BA
Top 1x Leg 4x
Cross brace 2x
ED
x4 tlob gnoLx61 tlob trohS
Spring washer 4x
GF
Flat washer 4x
Page 1 of 35514997/5515002/7044209- 02.28.08
angled leg side table
assembly instructions
1. Align 4 legs (B) so that the points all come together in the center like the drawing shows. Place 1 cross brace (C) into routes in top section and 1 cross brace (C) into routes in bottom section. Insert 1 short bolt into each of the 16 holes in the cross braces. Tighten with supplied allen key.
C
Allen key
D
D
C
Page 2 of 35514997/5515002/7044209 - 02.28.08
angled leg side table
assembly instructions
2. Lay top face down with the holes pointed upward. Next place assembled legs (B) with cross braces (C) onto top. Align holes from legs to top. Insert 1 long bolt (E) through 1 sping washer (F) and
at washer (G). Insert this bolt assembly into hole in leg assembly as shown. Repeat for all four
ip the table over.
Allen key
E
F
G
CARE INSTRUCTIONS Hardware may loosen overtime. Periodically check that all connections are tight.
nish, avoid the use of chemicals and household cleaners.
Page 3 of 35514997/5515002/7044209 - 02.28.08
Loading...