West Elm 2x2 Console, 2x2 Console Desk Assembly Instruction

2x2 console

assembly instructions

! Tools supplied:
! Do not throw away packaging materials until assembly is complete.
! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish.
! Proper assembly of this item requires 2 people.

Hardware

AB

lock washer 28x

m6 x 57mm long bolt 8x

C

E

m6 x 45mm short bolts 20x

D

flat washer 28x

wooden dowel 10mm x 40mm 8x

Page 1 of 402.19.10

desktop 1x

2x2 console

assembly instructions

bottom shelf 2x

corner legs 4x

center shelf 2x

inner legs 4x

Page 2 of 402.19.10

2x2 console

assembly instructions

1. Connect 2 corner legs and 2 inner legs to each center shelf by inserting short bolt (A), lock washer(B),
and  at washer(C). Make sure the 2 corner legs are on the same side of the shelf as shown.

C

B

A

2. insert wooden dowels(E) into the pre-drilled holes located on the bottom shelf. Align and connect
the assembled legs and shelf from step 1 to the wooden dowels in the bottom shelf. Insert bolt(D),
lock washer(B), and  at washer(C) thru bottom into legs. Tighten with supplied hex key.
Repeat this step for both sets of shelves.

C

B

D

E

E

Page 3 of 402.19.10

2x2 console

assembly instructions

3. Place the desktop upside down on a clean, soft surface. Align the 2 leg assemblies with the top as shown.
Insert bolt(A), lock washer(B), and Flat Washer(C) thru top blocks into legs. Tighten with attached hex key.

C

B

A

A

C

B

CARE INSTRUCTIONS
Hardware may loosen overtime. Periodically check that all connections are tight.
Wipe with a soft, dry cloth. To protect  nish, avoid the use of chemicals and household cleaners.

Page 4 of 402.19.10