! Tools required:
! Do not throw away packaging materials until assembly is complete.
! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish.
! Proper assembly of this item requires 2 people.
2x2 Bed Frame
assembly instructions
Hardware
bolt m8 x 16mm 10x
(Full, Queen, King, Cal .King)
C D
flat washer m6 x 13mm 10x
(Full, Queen, King, Cal .King)
E
allen key m4 x 110mm 1x
G
BA
spring washer m6 x 13mm 10x
(Full, Queen, King, Cal .King)
barrel nut m6 x 13mm x6
(Full, Queen, King, Cal .King)
F
bolt m8 x 16mm 8x
(Full, Queen, King, Cal .King)
allen key m5 x 110mm 1x
Page 1 of 410-01-09
2x2 Bed Frame
assembly instructions
1. insert bolt (F) into the headboard brackets and screw in halfway using m5 allen key (G). Attach side rails
by aligning hooks over bolts so that the hooks face inward. Do not completely tighten bolts.
2. Repeat step 1 to attach the footboard to the assembly. Fully tighten all bolts (F) using m5 allen key (G).
Page 2 of 410-01-09
2x2 Bed Frame
assembly instructions
at washers (C) as
shown below. Insert barrel nut (D) into the pre-drilled holes inside the legs. Thread the bolts (A) into the
barrel nuts (D). Tighten with allen key (E).
cross support
inside leg
at
washer (C). Tighten with allen key (E).
5. Adjust the pre-installed levelers under each leg as shown to correctly position to the bedframe so that
oor.
Page 3 of 410-01-09
6. Set slats into frame as shown. Repeat to insert the second set of slats.
2x2 Bed Frame
assembly instructions
CARE INSTRUCTIONS
Hardware may loosen overtime. Periodically check that all connections are tight.
nish, avoid the use of chemicals and household cleaners.
Page 4 of 410-01-09
Loading...