Westcode Semiconductors N0634LC380, N0634LC420 Data Sheet
Date:- 13 Feb, 2002
WESTCODE
Phase Control Thyristor
Types N0634LC380 to N0634LC420
Absolute Maximum Ratings
VOLTAGE RATINGS
V
DRM
V
DSM
V
RRM
V
RSM
I
T(AV)
I
T(AV)
I
T(AV)
I
T(RMS)
I
T(d.c.)
I
TSM
I
TSM2
I2tI
I2t
diT/dt
V
RGM
P
G(AV)
P
GM
V
GD
T
HS
T
stg
Repetitive peak off-state voltage, (note 1) 3800-4200 V
Non-repetitive peak off-state voltage, (note 1) 3800-4200 V
Repetitive peak reverse voltage, (note 1) 3800-4200 V
Non-repetitive peak reverse voltage, (note 1) 3900-4300 V
OTHER RATINGS
Mean on-state current. T
Mean on-state current. T
Mean on-state current. T
Nominal RMS on-state current. T
D.C. on-state current. T
Peak non-repetitive surge tp=10ms, Vrm=0.6V
Peak non-repetitive surge tp=10ms, V
2
t capacity for fusing tp=10ms, Vrm=0.6V
I2t capacity for fusing tp=10ms, V
Maximum rate of rise of on-state current (repetitive), (Note 6) 200 A/µs
Maximum rate of rise of on-state current (non-repetitive), (Note 6) 400 A/µs
Peak reverse gate voltage 5 V
Mean forward gate power 4 W
Peak forward gate power 30 W
Non-trigger gate voltage, (Note 7) 0.25 V
Operating temperature range -40 to +125 °C
Storage temperature range -40 to +150 °C
=55°C, (note 2) 634 A
sink
=85°C, (note 2) 451 A
sink
=85°C, (note 3) 288 A
sink
=25°C, (note 2) 1228 A
sink
=25°C, (note 4) 1123 A
sink
, (note 5) 7000 A
RRM
≤
10V, (note 5)
rm
, (note 5) 245×10
RRM
≤
10V, (note 5)
rm
Data Sheet Issue:- 1
MAXIMUM
LIMITS
MAXIMUM
LIMITS
7700 A
3
3
296×10
UNITS
UNITS
A2s
A2s
Notes: -
1)
De-rating factor of 0.13% per °C is applicable for Tj below 25°C.
2)
Double side cooled, single phase; 50Hz, 180° half-sinewave.
3)
Single side cooled, single phase; 50Hz, 180° half-sinewave.
4)
Double side cooled.
5)
Half-sinewave, 125°C Tj initial.
6)
VD=67% V
7)
Rated V
Data Sheet. Types N0634LC380 to N0634LC420 Issue 1. Page 1 of 10 February, 2002
, ITM=1000A, IFG=2A, t
DRM
.
DRM
≤
0.5µs, T
r
case
=125°C.
WESTCODE
Positive development in power electronics
Characteristics
N0634LC380 to N0634LC420
PARAMETER MIN. TYP. MAX. TEST CONDITIONS
V
V
r
S
dv/dt Critical rate of rise of off-state voltage 1000 - - VD=80% V
I
DRM
I
RRM
V
I
GT
I
H
t
gd
t
gt
Q
Q
I
rm
t
rr
t
q
R
Maximum peak on-state voltage - - 2.8 ITM=1100A V
TM
Threshold voltage - - 1.1 V
0
Slope resistance - - 1.5
Peak off-state current - - 100 Rated V
Peak reverse current - - 100 Rated V
Gate trigger voltage - - 3.0 V
GT
T
Gate trigger current - - 300
DRM
RRM
=25°C, VD=10V, IT=2A
j
Holding current - - 1000 Tj=25°C mA
Gate controlled turn-on delay time - 0.5 1.0
Turn-on time - 2.0 3.0
Recovered Charge - 1450 - µC
rr
Recovered Charge, 50% chord - 850 1200 µC
ra
Reverse recovery current - 90 - A
=67%V
V
D
I
=2A, tr=0.5µs, Tj=25°C
FG
I
=1000A, tp=1000µs, di/dt=10A/µs,
TM
V
=50V
r
Reverse recovery time, 50% chord - 19 -
ITM=1000A, tp=1000µs, di/dt=10A/µs,
V
=50V, Vdr=80%V
r
ITM=1000A, tp=1000µs, di/dt=10A/µs,
V
=50V, Vdr=80%V
r
Turn-off time
Thermal resistance, junction to heatsink
th(j-hs)
- 450 750
- 600 1000
--0.032 Double side cooled K/W
--
0.064 Single side cooled K/W
(Note 1)
, linear ramp, Gate O/C
DRM
, ITM=1000A, di/dt=10A/µs,
DRM
, dVdr/dt=20V/µs
DRM
, dVdr/dt=200V/µs
DRM
UNITS
m
V/µs
mA
mA
mA
µs
µs
µs
F Mounting force 10 - 20 kN
W
Weight - 340 - g
t
Ω
Notes: -
Unless otherwise indicated Tj=125°C.
1)
Data Sheet. Types N0634LC380 to N0634LC420 Issue 1. Page 2 of 10 February, 2002
WESTCODE
Notes on Ratings and Characteristics
1.0 Voltage Grade Table
Positive development in power electronics
N0634LC380 to N0634LC420
V
Voltage Grade
38 3800 3900 1950
40 4000 4100 2000
42 4200 4300 2040
2.0 Extension of Voltage Grades This report is applicable to other and higher voltage grades when supply has been agreed by Sales/Production.
3.0 De-rating Factor A blocking voltage de-rating factor of 0.13%/°C is applicable to this device for Tj below 25°C.
4.0 Repetitive dv/dt Standard dv/dt is 1000V/µs.
5.0 Rate of rise of on-state current The maxim um un-primed rate of r ise of on-state current mus t not ex c eed 400A/µs at any time during turnon on a non-repetitive basis. For repetitive performance, the on-state rate of rise of current must not exceed 200A/µs at any time during turn-on. Note that these values of rate of rise of current apply to the total device current including that from any local snubber network.
6.0 Gate Drive The recomm ended pulse gate drive is 30V, 15Ω with a short-circuit current rise time of not more than
0.5µs. This gate drive must be applied when using the full di/dt capability of the device.
DRM VDSM VRRM
V
V
RSM
V
V
V
D
DC V
R
The pulse duration may need to be configured acc ording to the application but should be no shorter than
20µs, otherwise an increase in pulse current may be needed to supply the necessary charge to trigger.
7.0 Computer Modelling Parameters
7.1 Device Dissipation Calculations
∆
2
4
=
I
AV
Where V0=1.1V, rs=1.5m
R
= Supplementary thermal impedance, see table below.
th
ff
= Form factor, see table below.
Conduction Angle 30° 60° 90° 120° 180° 270° d.c.
Square wave Double Side Cooled 0.0511 0.0455 0.0418 0.0393 0.0362 0.0336 0.032
Square wave Single Side Cooled 0.0845 0.0781 0.0743 0.0719 0.0689 0.0663 0.064
Sine wave Double Side Cooled 0.0456 0.0397 0.0369 0.035 0.033
Sine wave Single Side Cooled 0.0774 0.0714 0.0689 0.0674 0.0652
00
⋅⋅
2
rff
Ω,
⋅⋅⋅++−
WrffVV
AVs
and:
s
Supplementary Thermal Impedance
W
AV
=
R
T
th
max
−=∆
TTT
Hsj
Form Factors
Conduction Angle 30° 60° 90° 120° 180° 270° d.c.
Square wave 3.46 2.45 2 1.73 1.41 1.15 1
Sine wave 3.98 2.78 2.22 1.88 1.57
Data Sheet. Types N0634LC380 to N0634LC420 Issue 1. Page 3 of 10 February, 2002
Loading...