Westbrass DT1F271-XX User Manual

HotMaster™ DigiHot Instant Hot Water Appliance

Installation, Operation and Care Instructions

DT1F271-XX

WESTBRASS • 2429 E. Olympic Blvd., Los Angeles, CA 90021

(213)-627-8441

• fax:[phone] • [e-mail] • www.westbrass.com

Please read these instructions fully before commencing the installation

and operation of the Electronic Instant Hot Water Appliance.

1

Please read and fully understand this guide to the installation, operation and
maintenance for your Instant hot kitchen faucet.

If in doubt contact a qualied plumber or retailer to assist.

Do Not Plug In The Instant Hot

Water Tank Until Tank Is Full

For your safety and satisfaction please read all the instructions, cautions and warnings
before installing or using this electronic instant hot water appliance.
This electronic instant hot water appliance is not intended for commercial use.

Do not plug in tank until all water connections have been made and checked for being
water tight, and the Instant Hot Water Tank must be lled with water.

The Instant Hot Water Tank is lled only when water continually passes out of the faucet
spout. For Hot and Cold units, water must pass freely through the hot water side. It is
recommended to ush the tank, using several pints of water before operating. This will
ensure air is removed from system, and any residual carbon is removed from the lter.

IMPORTANT NOTICE: This product can cause harm if installed incorrectly and should
only be installed by a competent person. If you feel for any reason unsure about the
installation, please contact a qualied plumber or electrician to install the appliance.

PROPER DISPOSAL

Information on Disposal for Users of Waste Electrical & Electronic Equipment
(private households)

This symbol on the product and / or accompanying documents means that used elec­trical and electronic products should not be mixed with general household waste. For
proper treatment, recovery and recycling, please take this product to designated collec­tion points where it will be accepted free of charge.

• Make sure all electrical wiring and connections conform to local standards.

• Make sure all water connections conform to local standards.

• Make sure all electrical wiring and water connections conform to local codes.

• Standard 120v electrical outlet is required under the sink.

• If possible, use a separate circuit dedicated to your Hot Tank or use a dual outlet air

switch between the tank and the garbage disposal.

• The instant hot water appliance is an open vented system. Water will run out of the

spout when the tank is heating to prevent damage or explosions.

• The operating pressure is 22psi to maximum of 72psi.

• The water lter must be connected to the electronic instant hot water appliance

and replaced every 6 months or the guarantee will be void.

Tools you may need to install:

Tape Measure, Adjustable Wrench, PTFE Tape, Silicone, Screw Driver, Hack Saw, Tubing Cutter

SILICONE

2

Alternatively, in some countries you may be able to return your products to your local
retailer upon purchase of an equivalent new product.

Disposing of this product correctly will help save valuable resources and prevent any po­tential negative eects on human health and the environment, which could otherwise
arise from inappropriate waste handling.

Please contact your local authority for further details of your nearest designated collec­tion point.

Penalties may be applicable for incorrect disposal of this waste, in accordance with you
national legislation.

For business users in the European Union

If you wish to discard electrical and electronic equipment, please contact your dealer or
supplier for further information.

Information on Disposal in other Countries outside the European Union

This symbol is only valid in the European Union. If you wish to discard this product
please contact your local authorities or dealer and ask for the correct method of disposal.

15

TROUBLE SHOOTING GUIDE

PROBLEM POSSIBLE CAUSE WHAT TO DO

Slow Flow from the
spout

Water does not
ow immediately.

No water owing. Water valves have been

Water Filter may be
clogged from impurities
from the inlet water.

The electronic instant hot
water appliance is design
for non-pressurised opera­tion and there will be
slight delay till the nearly
boiling water appears.

turned o.

Inlet pipes have been
twisted or blocked.

The water lter must be changed
every 6 months or this will void
the warranty. Change the lter.

After a large volume of water
has been drawn o, it might take
slightly longer for the water to ap­pear from the spout.

Turn on all the water valves.

Ensure the pipes are not twisted or
kinked to restrict ow.

Remove the electronic instant
hot water appliance as per the
de-scaling instructions and ush
through all pipes to ensure water
ow.

SAFETY INSTRUCTIONS

The alert symbols displayed on the right points to important safety
information to make you aware of potential hazards that can cause
serious injury or death. Please pay special attention to the information
following these warning alerts. Failure to comply with these instruc­tions could result in property damage, serious injury or death.

Electric Shock:

Using an ungrounded connection or improper connection of the power supply to the
product can result in a serious injury or death from electrical shock.

• Do not remove the ground terminal

• Do not alter the plug

• Do not disassemble main box and any part of the power.

Important:

The instructions are only intended as a guide for a knowledgible individual. If there is
any doubt, please contact a certied plumber or electrician or point of purchase agent
and avoid using the appliance until it has been checked.

14

TO CLEAN:

Do not allow your product to come into contact with any cleansers forti-

Soft Scrub, Dawn Liquid Soap, Palmolive or any other combined cleaners
contain certain chemical components that will dissolve and remove the

warm water and mild soap on a soft cloth or sponge. Avoid using any
sponge with a scouring pad to clean your product. It is not necessary to
rub hard to remove spots.

Finishes:

Functional Warranty:

a rof detnarraw si stcudorp lla fo ytilanoitcnuf ehT

sealing compounds should be used instead. No repairs

retaw yna no sevlav csid cimareC .raey one fo doirep

or replacements will be made under
delivery merchandise are warranted for one year. Warran­ties are guaranteed to the original purchaser only. Product
problems attributable to abuse, misuse, improper instal­lation, hard water, neglected maintenance or accidental
damage are not covered by this warranty. Modifying the
product in any way voids the warranty. The use of plumb­er’s putty on our products also voids the warranty. Silicone

except at customer’s expense. Liability under warranties

expressed or implied is limited to repair or replacement of

defective goods only. In no event will Westbrass be liable for

incidental or consequential damages (such as labor charges).

This warranty does not cover labor charges, whether based on

breach of express or implied warranty, breach of contract,

negligence or any other legal theory.

CARE & MAINTENANCE

TO PROTECT:

An occasional application of Carnauba wax
(without cleaners), like that found in Flitz Fau­cet Wax, Turtle Wax for Clear Coat Car Finishes
or M cGuire’s Premium Wax, will enhance the

WARRANTY

such circumstances

INCLUDED COMPONENTS

The electronic instant hot water appliance is supplied with the following:

• Electronic Instant Hot Water Appliance with USA IEC power lead.

• 3/8 inch BPP x 1/4 inch insert tting and Nylon clamp*

• 3/8 inch BPP x 1/4 inch insert tank inlet tting*

• ShokBlok faucet and lter protection unit

• eco3+ lter cartrige, mounting head and bracket

• D271-NL-XX Instant hot only faucet

• Food Safe 1/4 inch PVC tubing

* The water connections are to allow correct connections from the instant hot water tap
to the electronic instant hot water appliance. Tank Inlets are 3/8 inch British Pipe Parallel

3