West Bend SIT10899 Owner's Manual
Register this and other Focus Electrics products through our website: www.registerfocus.com
A
RCTIC POPS™ MAKER
Instruction Manual
Important Safeguards ............................................................................................................................... 2
Before Using for the First Time ................................................................................................................. 3
Using Your Arctic Pops™ Maker .............................................................................................................. 3
Specialty Pops ......................................................................................................................................... 4
Helpful Hints ............................................................................................................................................. 5
Cleaning Your Arctic Pops™ Maker ......................................................................................................... 6
Starter Recipes ........................................................................................................................................ 6
Warranty .................................................................................................................................................. 7
SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE
2011 West Bend®, a Brand of Focus Electrics, LLC.
www.westbend.com
To prevent personal injury or property damage, read and follow all instructions and
warnings.
When using any appliances, basic safety precautions should always be followed including:
• Read all instructions, including these important safeguards and the care and use
instructions in this manual.
• This product is not a toy; close supervision is necessary when this appliance is used by or
near children.
• Should leakage occur, discontinue use immediately and contact customer service for
assistance.
• Do not touch the Arctic Pops™ maker with your hand, especially with wet fingers. If your
fingers stick to the mold, run them under warm water.
• To avoid damaging the Arctic Pops™ maker, always store it in the freezer upside down
and in a level position.
• Do not use plain water or sugar-free liquids in the Arctic Pops™ maker. Ice pops made
without sugar are extremely difficult to remove from the mold, and may lead to breakage
of the ice pop sticks.
• Do not use sharp or metal utensils or blades inside the Arctic Pops™ maker. This could
lead to damage of the non-stick coating.
• Do not use the Arctic Pops™ maker over flames, hotplates, stoves, or expose to a heat
source.
• Do not drop the Arctic Pops™ maker.
• Household use only.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS
2
Arctic Pops™ Stick
Drip Cup
Removal Tool
Mold Openings
B
EFORE USING FOR THE FIRST TIME
Please check all packaging material carefully before discarding. Many accessory parts are
contained within the packaging material. Your Arctic Pops™ Maker includes 8 Arctic Pops™
sticks, 4 drip cups, and 1 removal tool.
Follow directions in “Cleaning your Arctic Pops™ Maker” section of this manual to clean Arctic
Pops™ maker. Make sure the Arctic Pops™ mold is thoroughly dried after cleaning. Water will
freeze inside the mold and make ice pop removal almost impossible.
Place clean, dry Arctic Pops™ maker in the freezer upside down for 24 hours. Your freezer must be
set to 0°F or lower for proper freezing of the mold.
U
SING YOUR ARCTIC POPS™ MAKER
1. Remove Arctic Pops™ maker from the freezer. Shake gently; if you hear sloshing, it is not
completely frozen. Place back in the freezer and freeze longer; at least one hour. Check to
make sure your freezer is set to 0°F or lower.
3
2. Quickly place the ice pop sticks into the mold openings. Sticks should be placed so they sit
inside the X shape of the freezing mold. Carefully pour chilled ingredients into the Arctic
Pops™ mold opening up to the fill line. Do not use sugar free liquids, plain water, or
carbonated beverages in the Arctic Pops™ maker, as ice pops will be nearly impossible to
remove.
3. Watch pops freeze before your eyes! If the Arctic Pops™ maker has been properly frozen,
and ingredients were pre-chilled, ice pops should be ready in about 10 minutes. Times will
vary depending on ambient temperature, ingredients, and freezer temperature.
4. When the ice pop is completely frozen, no liquid
remains at the center of the pop. Use the Arctic
Pops™ removal tool to remove the ice pop from
the mold. Slide the notches of the removal tool
under the lip of the Arctic Pops™ stick. Push
down using the removal tool as a lever to lift the
ice pop out of the mold.
5. If desired, snap a drip cup to the bottom of the
Arctic Pops™ stick, bowl side up.
6.
To make more pops, repeat steps 2-5. Arctic
Pops™ maker should stay frozen long enough to
make up to 3 batches of ice pops. Any batches
after the first will take longer to freeze. Do not
wash Arctic Pops™ mold between batches.
S
PECIALTY POPS
• Striped Pops – Striped pops can easily be achieved with your Arctic Pops™ maker. Pick
flavors you would like to use and pour first flavor into the Arctic Pops™ mold. Let first
flavor freeze. Once frozen, add second flavor to desired level. Repeat until you have filled
the Arctic Pops™ mold to the fill line.
• Striped Pops with a Slant – For even more creativity, tilt your Arctic Pops™ maker by
propping up one side of the mold to the desired angle. Perform steps above for a striped
pop. When you get to the last flavor, remove the prop and fill the mold to the fill line.
•
Flavored-center Pops – Make ice pops with different flavored centers. To achieve this, fill
the Arctic Pops™ maker with the desired shell flavor and let begin to freeze. Thickness of
the shell is dependent on how long you let it freeze. When shell has reached desired
thickness, use a straw to drink out the liquid remaining in the pop, then fill the opening with
your desired center flavor. Let freeze completely. Note: some tasty center flavors can be
made with melted ice cream, yogurts, instant pudding, or puréed fruits.
4
H
ELPFUL HINTS
• Do not use sugar-free or artificially sweetened ingredients. If you do not use sugar, or if
artificial sweeteners are used, the pops will be impossible to remove from the mold. In
order to release properly, there must be some sugar in the mix. Ingredients with natural
sweeteners such as molasses, honey, fruit juices, or even maple syrup work well! These
will improve the flavor of your pop and will make your ice pops easier to remove from the
mold.
• Because of their soft consistency, ice cream, yogurt, and pudding may be difficult to
remove from the mold. They may not hold on to the Arctic Pops™ stick when trying to
remove.
• Use instant pudding mix to make pudding pops. Mix pudding mix according to package
instructions; immediately pour into the mold. This will prevent your pudding pops being
lumpy or full of bubbles. Cooked and sugar-free puddings do not work as well in the Arctic
Pops™ maker.
• Do not try to force out a pop that is stuck. Forcing with the removal tool may result in a
broken stick or removal tool. To remove any ice pops that will not come out, run the pop
under lukewarm water to thaw and rinse out the mold opening or let Arctic Pops™ maker
sit at room temperature until thawed.
• Store the Arctic Pops™ maker in the freezer between uses. This will allow you to have ice
pops on demand at any time. To prevent freezer burn, store the Arctic Pops™ maker in a
plastic bag. To avoid damaging the Arctic Pops™ maker, always store it in the freezer
upside down and in a level position.
• Always thoroughly dry the Arctic Pops™ maker after washing. Any water left in the Arctic
Pops™ mold opening will make removal of the next ice pops very difficult.
• Soft drinks can be used to make tasty ice pops, BUT, ensure that the soft drink is flat
(non-carbonated) before freezing. If the soft drink is used while still carbonated, the ice
pops have a tendency to expand beyond the fill line, which makes them very difficult to
remove.
5
C
LEANING YOUR ARCTIC POPS™ MAKER
1. Let Arctic Pops™ maker thaw completely before washing. This will prevent water from
freezing in the Arctic Pops™ mold openings. Do not wash any part of the Arctic Pops™
maker in the dishwasher.
2. Wash all parts in warm, soapy water. Do not use abrasive cleansers or scrubbers to clean
the Arctic Pops™ maker. Rinse and dry thoroughly. Make sure that ALL water is removed
from inside the Arctic Pops™ mold before freezing. Water will make ice pop removal
almost impossible.
3. Washing may not be necessary after every use. If desired, place Arctic Pops™ maker
back in the freezer when done making ice pops. Do not store the drip cups or sticks in the
freezer in between uses.
S
TARTER RECIPES
While most juices, flat soft drinks, and beverages can be used alone to make an ice pop, here
are some basic recipes to get you started.
• Use West Bend® syrups in a 1 to 1 ratio to make ice pops, 1 part syrup to 1 part water.
Follow basic directions to make ice pops. Do NOT use any sugar-free syrups to make ice
pops.
• Fruit Juice Pops - Pour fruit juice of your choice into the mold openings. Follow basic
instructions for making ice pops. Fruit juices can be mixed and matched for different flavor
combinations. Or, pour and freeze juices in layers. Begin with one flavor, freeze, then add
a second flavor.
• Orange Cream Pops - Follow directions in “Specialty Pops” section of this manual for
Flavored-center Pops; pour our orange juice into mold openings. Let freeze until an outer
shell has been formed. Pour or drink out liquid juice, pour melted vanilla ice cream or
vanilla yogurt until ice pop has been filled.
• Root Beer Float Pops - Follow directions in “Specialty Pops” section of this manual for
Flavored-center Pops; pour flat root beer into mold openings. Let freeze until an outer
shell has been formed. Pour or drink out liquid juice, pour melted vanilla ice cream or
vanilla yogurt until ice pop has been filled.
• Blueberry Lemonade Pops - Purée blueberries with enough lemonade to make purée
pourable. Pour a lemonade layer into Arctic Pops™ maker, freeze, pour a layer of
blueberry purée and freeze. Repeat until Arctic Pops™ makers are full. Also works well
with strawberries or raspberries.
6
P
RODUCT WARRANTY
Appliance 1 Year Limited Warranty
Focus Electrics, LLC (“the company”) warrants this appliance from failures in the material and workmanship for one (1)
year from the date of original purchase with proof of purchase, provided the appliance is operated and maintained in
conformity with the provided Instruction Manual. Any failed part of the appliance will be repaired or replaced without
charge at the company’s discretion. This warranty applies to indoor household use only.
This warranty does not cover any damage, including discoloration, to any non-stick surface of the appliance. This
warranty is null and void, as determined solely by the company if the appliance is damaged through accident, misuse,
abuse, negligence, scratching, or if the appliance is altered in any way.
THIS WARRANTY IS IN LIEU OF ALL IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE, PERFORMANCE, OR OTHERWISE, WHICH ARE HEREBY EXCLUDED.
IN NO EVENT SHALL THE COMPANY BE LIABLE FOR ANY DAMAGES, WHETHER DIRECT, INDIRECT,
INCIDENTAL, FORSEEABLE, CONSEQUENTIAL, OR SPECIAL, ARISING OUT OF OR IN CONNECTION WITH THIS
APPLIANCE.
If you think the appliance has failed or requires service within its warranty period, please contact the Customer Service
Department at (866) 290-1851, or e-mail us at service@focuselectrics.com. A receipt proving the original purchase date
will be required for all warranty claims, hand written receipts are not accepted. You may also be required to return the
appliance for inspection and evaluation. Return shipping costs are not refundable. The company is not responsible for
returns lost in transit.
Valid only in USA and Canada
R
EPLACEMENT PARTS
Replacement parts, if available, may be ordered directly from the company several ways. Order online at
www.focuselectrics.com, e-mail service@focuselectrics.com, over the phone by calling (866)290-1851, or by writing to:
Focus Electrics, LLC
Attn: Customer Service
P. O. Box 2780
West Bend, WI 53095
To order with a check or money order, please first contact Customer Service for an order total. Mail your payment along
with a letter stating the model or catalog number of your appliance, which can be found on the bottom or back of the unit,
a description of the part or parts you are ordering, and the quantity you would like. Your check should be made payable
to Focus Electrics, LLC.
Your state/province’s sales tax and a shipping fee will be added to your total charge. Please allow two weeks for
processing and delivery.
This manual contains important and helpful information regarding the safe use and care of your new product. For future
reference, attach dated sales receipt for warranty proof of purchase and record the following information:
Date purchased or received as gift: _______________________________________________
Where purchased and price, if known: _____________________________________________
Item number and Date Code (shown bottom/back of product):___________________________
L5835B 10/11 West Bend®, a Brand of Focus Electrics, LLC. Printed in China
7
7
N
OTES
8
Loading...