The massager (C) requires four ÒCÓ
batteries (not included). Alkaline batteries
are recommended.
To install batteries, first turn the float (A)
so the head rest (not shown) is downward. Next, remove the six screws (G)
from the battery cover (E) and lift off the
battery cover. Press four ÒCÓ batteries into
the massager; make sure that each bat-
tery is turned as shown on the inside
of the massager. Reattach the battery
cover with the six screws.
Before using the MASSAGE POOL FLOAT, make sure that you
have read all warnings in this UserÕs Guide.
Turn the float (A) so the
head rest and the massage pad (B) are on top.
Place the float in the
water. Enter the water
and climb onto the float.
To activate the massager, press the on/off
button on the massage
pad. Press the on/off
button again to turn off
the massager.
¥ This is not a life-saving device.
¥ Never leave a child in or near water without the constant
supervision of a competent adult swimmer. Flotation toys are
not substitutes for proper supervision.
¥ Use only in pools where every child present is within his or
her depth.
¥ Do not allow diving onto this product.
¥ To avoid attracting children to the water, remove this toy from
the pool area when it is not being used.
¥ Do not use in the ocean or other natural bodies of water as
depth, waves, and currents may pose serious hazards.
¥ Misuse may result in serious injury, disability, or death by
drowning.
1. Turn the float (A) so the head rest
is downward as shown.
2. Insert the six posts on the massage pad (B) into the six small
holes in the float. Make sure that
the dimple in the massage pad is
turned toward the head rest.
3. Press the massager (C) into the
square hole in the float. Make sure
that the on/off switch on the
massager is pressed into the
dimple in the massage pad.
4. Place the back plate (D) over the
massager so the cutout in the back plate is aligned with the battery
cover (E). Firmly press the six fasteners (F) into the back plate and
the posts on the massage pad.
5. Make sure that all six fasteners (F) are
pushed completely into the posts on the
massage pad (B) by firmly pressing on
each fastener while pressing on the
massage pad from below.
B
Post
Dimple
Head
Rest
C
E
A
D
F
A
B
Head Rest
On/Off
Button
G
E
C
A
Warnings
Using the MASSAGE POOL FLOAT
Battery Installation
Assembly
F
B