Weslo WL540030 Owner's Manual

®

USER'S MANUAL

QUESTIONS?

As a manufacturer, we are
committed to providing com­plete customer satisfaction. If
you have questions or find that
there are missing or damaged
parts, we will guarantee you
complete satisfaction through
direct assistance from our
factory.

TO AVOID UNNECESSARY
DELAYS, PLEASE CALL DIRECT
TO OUR TOLL-FREE CUSTOMER
HOT LINE. The trained techni­cians on our customer hot line
will provide immediate assis­tance, free of charge to you.

CUSTOMER HOT LINE:

1-800-999-3756

Mon.ÐFri., 6 a.m.Ð 6 p.m. MST

CAUTION

Read all precautions and instruc­tions in this manual before using
this equipment. Save this manu­al for future reference.

Model No. WL540030

Visit our website at

www.weslo.com

new products, prizes,

fitness tips, and much more!

¨

IMPORTANT PRECAUTIONS

WARNING: To reduce the risk of serious injury, read the following important precautions before you
use the WESLO 540.

2

BEFORE YOU BEGIN

Thank you for selecting the WESLO¨540 Adjustable
Resistance Rowing Machine. Rowing is one of the
most effective exercises known for toning the body,
strengthening the muscles, and building the cardiovas­cular system. The WESLO 540 is designed to let you
enjoy this effective exercise in the convenience and
privacy of your home.

For your benefit, read this manual carefully before
you use the WESLO 540. If you have additional ques-

tions, please call our Customer Service Department
toll-free at 1-800-999-3756, Monday through Friday,
6 a.m. until 6 p.m. Mountain Time (excluding holidays).

To help us assist you, please note the product model
number and serial number before calling. The model
number is WL540030. The serial number can be found
on a decal attached to the WESLO 540 below the
monitor.

WARNING: Before beginning this or any exercise program, consult your physician. This is especial­ly important for persons over the age of 35 or persons with pre-existing health problems. Read all
instructions before using. ICON assumes no responsibility for personal injury or property damage
sustained by or through the use of this product.

1. Read all instructions in this manual before
using the rowing machine. Use the rowing
machine only as described.

2. It is the responsibility of the owner to ensure
that all users of the rowing machine are ade­quately informed of all warnings.

3. Use the rowing machine indoors, on a level

surface, away from moisture and dust. Place
a mat under the rowing machine to protect
the floor or carpet.

4. Inspect and tighten all parts of the rowing

machine regularly. Replace worn parts imme­diately.

5. Always tighten the seat knob before lifting or

moving the rowing machine. If the seat knob

is not tightened, the seat could slide, result­ing in injury.

6. Keep children under 12 and pets away from
the rowing machine at all times.

7. Wear appropriate clothing when exercising.
Always wear athletic shoes for foot protection.

8. Keep your hands away from moving parts.

9. If you experience dizziness or pain at any
time while exercising, stop immediately and
begin cooling down.

10.The rowing machine is intended for in-home
use only. Do not use the rowing machine in a
commercial, rental, or institutional setting.

1. Insert two new ÒAAÓ batteries (not included) into the
Monitor (15). Alkaline batteries are recommended.
Make sure that the batteries are turned as shown
inside the Monitor.

Insert the two tabs on the Monitor (15) into the slots
near the front end of the Rail (2). Attach the Monitor to
the Rail with the Monitor Screw (14).

2. Attach the Seat (23) to the Seat Bracket (24) with the
four Seat Screws (37). Note: The thickest part of the
Seat is the back. The Seat can be turned so the Seat
Knob (27) is on either the left or right side of the Seat.

3. Pull the Rail Cap (6) out of the back end of the Rail
(2). Remove the M8 Nylon Locknut (9), the Seat
Stops (5), and the Seat Stop Bolt (4) from the back
end of the Rail.

Roll the Seat (23) onto the Rail (2). Make sure that
the thickest part of the Seat is at the back.

Reattach the Seat Stop Bolt (4), the Seat Stops (5),
and the M8 Nylon Locknut (9) to the Rail (2). Press
the Rail Cap (6) back into the Rail.

3

1

14

15

Tabs

2

6

2

4

5

5

9

23

37

37

27

24

23

3

ASSEMBLY

Place all parts of the rowing machine in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed. Read each step carefully before beginning.

ASSEMBLY REQUIRES THE FOLLOWING TOOLS (NOT INCLUDED): An adjustable wrench
and a phillips screwdriver .

2