Wesco 240020 User Manual

Knock Down Drum Truck

d

(Part # 240020)

Industrial Products, Inc.

Operating Instructions and Parts Manual

ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR WESCO DRUM

TRUCK, READ THESE INSTRUCTIONS BEFORE USING.

The Wesco Knock Down Drum Truck is designed specifically
for lifting 30 and 55 gallon poly drums. The truck is sent
knocked down and boxed, requiring minimal assembly before
operation. It features completely removable and
interchangeable parts.

This product is distributed by:

Wesco Industrial Products, Inc

1250 Welsh Road
North Wales, PA 19454
Tel: [phone] Fax: [phone]

Contact the factory for parts information and ordering.
Visit us on the web at www.wescomfg.com

When unpacking the Wesco Product, check carefully for
shipping damage and missing parts. If damage has occurred
or any parts are missing, file a claim with the delivering carrier
within 24 hours and notify the dealer from whom the unit was
purchased.

If the unit does not work properly, contact your dealer or the
factory (215-699-7031) for units less than 90 days old.

If units are older than 90 days, repairs can be made easily on
site with factory supplied parts.
NOTE: Do not send units to the factory for service without
first obtaining a “Return Merchandise Authorization” (RMA)
number from the customer service department. We will not
be responsible for merchandise returned without proper
authorization.

 DO NOT move with drum unless truck’s nose prongs are

positioned evenly and fully under drum.

 Use extreme caution when moving over uneven floors.
 DO NOT use on stairs or inclines.
 Use only for handling 30 or 55 gallon poly drums.
 Periodically check for loose or worn hardware; If found

LIMITED WARRANTY

WESCO INDUSTRIAL PRODUCTS (WESCO) warrants to the purchaser of this product for a period of ninety (90) days from the date of purchase that this product shall be free of
defects in material and/or workmanship, as follows:

1. WESCO will supply, at no charge, new or rebuilt replacements for any part that fails through a defect in material and/or workmanship during the warranty period. To obtain warranty
service, you must deliver the product prepaid, to the WESCO factory.

2. This warranty does not cover any product or product part which has been subject to accident, misuse, abuse or negligence. WESCO shall only be liable under this warranty if the
product is used the manner intended by the manufacturer as specified in the written instructions furnished with this product.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. ANY EXPRESS WARRANTY NOT PROVIDED IN
THIS WARRANTY DOCUMENT, AND ANY REMEDY FOR BREACH OF CONTRACT THAT, BUT FOR THIS PROVISION, MIGHT ARISE BY IMPLICATION OR OPERATION OF LAW,
IS HEREBY EXCLUDED AND DISCLAIMED. UNDER NO CIRCUMSTANCES SHALL WESCO BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY, EXPRESS OR IMPLIED, A BREACH OF CONTRACT OR OTHERWISE. EXCEPT TO THE
EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR PURPOSE ARE EXPRESSLY LIMITED
IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
Some states do not allow the exclusion or limitation of incidental or consequential damages, or allow limitations on how long any implied warranty lasts, so the above limitations may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Description

Unpacking

Warranty Repairs

Non-Warranty Service

Warning

Part No. Description

050138 Handle
109364 Hand Grips (each)
240219 KDT Poly Toe Set (SS)
150691 10” Polyolefin Wheel
109441 Kickstand (SS)
050458 Axle (SS)
108323 Pin: Cotter 3/16 x 1-1/2” (SS)
108328 Washer: Flat 1” (SS)
240218 Rear Rest (SS)
101148 Pin: Clevis 3/8” Dia. X 2-1/4” (SS)
108284 Bolt: Carriage 5/16-18 x 1” (SS)
109510 Washer: Flat 3/8 SAE (SS)
109638 Screw: Hex Hd. Cap 5/16-18 x 2-½” (SS)
150269 Nut: Keps 5/16-18 (SS)
109636 Screw: Hex Head Cap 5/16-18 x 3” (SS)
101149 Pin: Hair, Fits ¼ to ½ Dia. X 1-3/8” L (SS)
240213 Belt Assembly (SS)

Optional Parts for Steel Conversion

Part No. Description

240211 3
050197 Hook Slide (SS)
240220 Noseprong Steel Drum Set (SS)

Warning: The Wesco Knock Down Drum Trucks are
intended for specific functions. Please adhere to the
following instructions to insure safe and proper use.

(1) Maximum capacity - 1000 Lbs.
(2) Do not exceed rated capacity. Injury to persons or

property may result from overloading and misuse.

(3) Only use on Poly Drums unless properly converted!

(1) To properly operate the Knock Drum Truck DO NOT Pull

Back Drum Until:
a. Either the chime hook securely engages drum rim or

belt is securely tightened.

b. Both of truck’s nose prongs are in full contact with

bottom of drum.

(2) Tilt drum with caution, maintaining control throughout.

PATENT PENDING

Replacement Parts

r

Wheel Assembly (SS)

General Safety Information

Operating Instructions

159270A