The warnings, cautions, and instructions outlined in this instruction manual cannot cover all
possible conditions or situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product and must be
supplied by the operator.
PROP 65 WARNING
The engine exhaust from this product contains chemicals known to the state of California to
cause cancer, birth defects, or other reproductive harm.
GENERAL WARNINGS
READ and UNDERSTAND this manual completely before using 22 Ton Log Splitter.
Operator must read and understand all safety and warning information, operating instructions,
maintenance and storage instructions before operating this equipment. Failure to properly operate and
maintain the log splitter could result in serious injury to the operator or bystanders.
Operation Warnings
Do not at any time carry passengers, sit or stand on the log splitter.
Do not allow children to play on, stand upon or climb on the log splitter.
Always inspect the log splitter before using to assure it is in good working condition.
Replace or repair damaged or worn parts immediately.
Always check and tighten hardware and assembled parts before operation.
Do not exceed equipment maximum load capacity of 22 tons.
Avoid large holes and ditches when towing the equipment.
Always operate the log splitter on clear and level ground.
Do not operate the log splitter at night, only during daylight hours.
Always tow at reduce speed in rough terrain, along creeks, ditches and on hillsides.
To avoid personal injury and/or equipment damage DO NOT EXCEED 45 MPH.
Always refer to the vehicle owner’s manual for proper towing.
Always secure and lock the log splitter to the vehicle hitch before towing.
.
Crush and Cut Hazards
Always keep hands and feet clear from moving parts while operating the equipment.
Always clear and keep work area clean and free of debris when operating.
Always wear safety gear, eye protection, gloves and work boots when operating the log
splitter.
.
Assembly Is Required
This product requires assembly before use. See “Assembly” section for instructions. Because of the
weight and/or size of the log splitter, it is recommended that another adult be present to assist with the
assembly. INSPECT ALL COMPONENTS closely upon receipt to make sure no components are
missing or damaged.
.
- 3 -
This is the safety alert symbol. It is used to alert
you to potential personal injury hazards. Obey all
safety messages that follow this symbol to avoid
possible injury or death.
DANGER indicates an imminently hazardous
situation which, if not avoided, will result in death
or serious injury.
DANGER
WARNING indicates a potentially hazardous
situation which, if not avoided, could result in
death or serious injury.
WARNING
CAUTION indicates a potentially hazardous
situation which, if not avoided, may result in minor
or moderate injury.
CAUTION
CAUTION used without the safety alert symbol
indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
CAUTION
Hazard Signal Word Definitions
ABOUT YOUR 22 TON LOG SPLITTER
This hydraulic log splitter has a heavy-duty steel construction and 22 tons of ram force. When there's
work to be done, you need outdoor power equipment you can rely on, this log splitter will get the job
done fast. It is designed to work in both the horizontal and vertical position. It is easy to tow, easy to
use and maintain.Never exceed the rated capacity of 22 tons when operating the log splitter.
Technical specifications on the log splitter are provided in the “Specifications” section of this manual.
- 4 -
Controls and Features Identification
Read this owner’s manual before operating the equipment. Familiarize yourself with the location and
function of the controls and features. Save this manual for future reference.
1) 2” Coupler – Attaches the log splitter to the 2” ball.
2) Hydraulic Cylinder - 4” bore and 23” stroke, rated to 3500 psi.
3) Control Valve Lever – Controls the forward and backward movement of splitting wedge.
4) 8” Wedge - Features wedge wings and tapered ends making splitting easier.
5) Log Cradle – Holds the log on the beam without operator assistance.
6) Beam - 6” extra wide flange.
7) Engine - Air cooled 208cc engine powers the hydraulic pump.
8) Tires - Maximum rated towing speed is 45 MPH.
9) Gear Pump- Pumps the hydraulic oil through the system.
10) Support Legs - Supports the log splitter while operating.
11) Safety Chains - Safety feature to prevent loss of log splitter while towing.
- 5 -
CAUTION
Read and follow all instructions for assembly and operation. Failure to properly assemble this
equipment could result in serious injury to the user or bystanders, or cause equipment damage.
Engine Shipped Without Oil.
Before starting engine, fill with SAE 10W-30 motor oil.
See engine manual for engine oil capacity.
Hydraulic Oil Tank is Shipped Without Oil.
When adding oil verify the oil level reads 1 from the top of hydraulic oil
tank if marking is not shown fill to the neck.
Inspect all Log Splitter Components.
If you have damaged components: Contact the freight company that
delivered the log splitter and file a claim.
Assembly Instructions
22 TON LOG SPLITTER ASSEMBLY
Set the shipping crate on a solid flat surface and carefully remove the lid. Use two people and take
all parts out of the shipping crate and inspect the components to ensure there are no missing pieces
before starting to assemble the log splitter follow steps 1 through 12.