Wells Sinkware TOT3221-88 User Manual

WellsSinkware.com

I T ' S A W A T E R T H I N G

IN STALLATION INSTRUCTIONS

Clean your countertop and position the cutout template on it as desired. Using a pencil
to draw a line on the countertop along the edge of the cutout template.

Remove protective film from foam
sealing strip. Apply the foam seal
approximately 1/4 inch from the edge
of the sink. Do not stretch foam strip
and m a k e s u r e t h e e n d s m e e t
seamlessly.

For laminated or wood countertop, drill
starter hole and cut along the line
traced around the template; for granite,
m a r b l e o r o t h e r s o l i d s u r f a c e
countertop, your fabricator will cut it
accordingly.

WellsSinkware.com

I T ' S A W A T E R T H I N G

Slip the mounting clips over the sink rails and into the holes on the rail (the 1-prong side
of the clip should face the sink bowls). Rotate the clips according to the thickness of your
countertops (see illustration).

Tighten screws in mounting clips with a phillips screwdriver by hand. Warning: Use of a
drill or power screw driver can strip screws!

WE LL S SINKWARE COR P.

916 W. 21 Street

st

Chicago, IL 60608

Phone: [phone]

Fax: [phone]
Email: [e-mail]