Wells Manufacturing MDMW-2 Service Manual

©1985 McDonald's Corporation Printed In All Rights Reserved

MARINATOR WELLS

MODEL MDMW-2

Place this chapter in the Marinators section of the Equipment Manual.

MANUFACTURED EXCLUSIVELY FOR

McDONALD'S® BY

WELLS MANUFACTURING

2 ERIK CIRCLE VERDI, NEVADA 89439

PHONE: [phone](800) 648-6230 TELEX: 170074

TABLE OF CONTENTS

WARRANTY..................................................................................................................Page 2

INTRODUCTION ......................................................................................................... Page 2

SAFETY........................................................................................................................Page 2

PARTS IDENTIFICATION/FUNCTION/PHOTO ...............................................................Page 3

EQUIPMENT SET-UP AND CLOSE PROCEDURES .......................................................Page 7

TROUBLESHOOTING...................................................................................................Page 7

NON-SCHEDULED MAINTENANCE...............................................................................Page 9

ORDERING/SERVICE INFORMATION...........................................................................Page 9

WIRING DIAGRAM......................................................................................................Page 11

WIRING PICTORIAL....................................................................................................Page 12

Printed in October The United States of America

MARINATOR WARMERS

PRODUCT FEATURES

Models MDMW-2 and MDMW-3

• Thermostatically controlled to maintain precise
temperature.

• Sides and bottom fully insulated to prevent heat loss.

• Convenience outlet and mounting bracket for product timer.
MDMW-2 has mounting bracket on the back of the unit.
MDMW-3 has mounting bracket on the side (either) of the
unit to facilitate operation from front to back.

• Two-piece bacon/sausage divider separates product and is
easy to clean.

• Indicator lights for power and water temperatures.

• Rail mount base on MDMW-2 increases usable work space
on prep table.

• Four rubber feet on MDMW-3 Marinator.

ELECTRICAL INFORMATION Voltage: 120V single phase.
Power: .9 KW, 7.5 amps, plus convenience outlet. MDMW-2
Marinator is provided with a 6-foot cord with a L5-20P twist­lock connector for power. MDMW-3 Marinator is provided with
a 6-foot cord with a 125V, 20 amp, 2-pole/three wire, 320
P4W pin-and-sleeve connector for power.

PRODUCT FINISH All stainless
steel construction.

PRODUCT WARRANTY

The Marinator Warmers manufactured by Wells are warranted
to be free from defects in materials and workmanship for a
period of one year from the date of original installation and is
for the benefit of the original purchaser only. This warranty
does not apply to damage resulting from fire, water, burglary,
accident, abuse, misuse, acts of God, faulty installation
including improper electrical supply.

THIS WARRANTY IS THE COMPLETE AND ONLY WARRANTY,
THERE BEING NO OTHER WARRANTIES, EXPRESSED OR
IMPLIED IN LAW OR IN FACT, INCLUDING BUT NOT LIMITED TO,
WARRANTIES OF MERCHANT-ABILITY OR FITNESS FOR ANY
PARTICULAR PURPOSE, AND/OR FOR DIRECT, INDIRECT, OR
INCONSEQUENTIAL DAMAGES IN CONNECTION WITH WELLS'
PRODUCTS.

Wells' obligation under this warranty is limited to the repair of
defects or replacement without charge by a WELLS factory
authorized service agency or one of its sub-service agencies.
This service will be provided on customer's premises.

WARRANTY

SAFETY

This MDMW-2 Marinator manufactured by Wells is
warranted to be free from defects in materials and
workmanship for a period of one year from the date
of original installation and is for the benefit of the
original purchaser only but is not against damage
caused by abuse, faulty installation, including
improper electrical current (125 volts, AC). THIS
WARRANTY IS THE COMPLETE AND ONLY
WARRANTY, THERE BEING NO OTHER
WARRANTIES, EXPRESSED OR IMPLIED IN
LAW OR IN FACT. INCLUDING BUT NOT LIMITED
TO. WARRANTIES OF MER-CHANTABILITY OR
FITNESS FOR ANY PARTICULAR PURPOSE,
AND/OR FOR DIRECT, INDIRECT, OR
CONSEQUENTIAL DAMAGES IN CONNECTION
WITH WELLS PRODUCTS.

Wells' obligation under this warranty is limited to the
repair of defects or replacement without charge by a
WELLS factory authorized service agency or one of
its sub-service agencies. This service will be
provided on customer's premises.

Please contact the Service Department: Wells
Manufacturing Company, P.O. Box 280, Verdi,
Nevada 89439; to arrange service or for additional
information and other details concerning the product
and/or this warranty.

INTRODUCTION

This Commercial, Counter top marinator Model
MDMW-2 is designed to be used wet. The unit will
hold food at the desired serving temperatures. Wet
operation distributes heat evenly to the food which is
to be placed on false bottom trays provided.

Knowledge of proper installation, operation and
maintenance procedures is essential to insure safe
operation of any equipment. The instructions in this
chapter are meant as guidelines; major
considerations to be kept always in mind are:

1. Use dry hands to turn power switch on or off.

2. Turn off power switch anytime marinator is not in
use.

3. If an electric shock is felt when touching the
cabinet, disconnect immediately. Call Wells
Service Department for repair.

4. Have electrical supply outlet installed by a
licensed electrician. Make sure that: equipment is
properly grounded.

5. If you find that the electrical cord is frayed, DO
NOT PLUG INTO A RECEPTACLE.

If it is already plugged in, disconnect the plug after
shutting off the circuit breaker.

6. DISCONNECT POWER CORD BEFORE
ATTEMPTING ANY REPAIRS AND/OR CLEANING
THE UNIT WITH WATER.

7. Allow unit to cool before cleaning.

8. DON'T EVER SPLASH WATER WITH A HOSE OR
OTHERWISE ONTO THE UNIT. WET ELECTRICAL
COMPONENTS AND WIRING MAY PRESENT A
SHOCK HAZARD.

9. DON'T REMOVE SCALE FROM PAN WITH A SHARP
KNIFE - FOLLOW CLEANING PROCEDURE
DESCRIBED ON THE PLANNED MAINTENANCE
SYSTEM CARD #61.

2

ITEM

PART

NO.

PARTS IDENTIFICATION/FUNCTION/PHOTOS

DESCRIPTION QTY. FUNCTION

1 21077 Marinator with 2/3rd Size Pan 1

2 61132 2/3rd Size Pan 1

3 61155 False Bottom Tray 1
4 61149 Lids 2 Lids to cover pan.

5 61728 Timer Bracket 1 To mount the countdown timers.

6 60648 Cord Set 1

7 61980 Product Divider Insert 1 Used to separate products.
8 61981 Product Divider — Center 1 Used to separate products.

Marinator to hold hot food in 2/3rd size pan
equipped with false bottom tray, lids, 2 piece
divider and timer mounting bracket.

Pan equipped with false bottom tray to hold
food.

To hold hot food and let grease drip thru holes
onto water (5 oz. per pan).

Protective wire set to connect appliance to
electrical supply system and to ground the unit.

3