Wells TOT322188, CHT252210L, CHT25228L, GLT332299LG Installation Manual

WellsSinkware.com
I T ' S A W A T E R T H I N G
IN STALLATION INSTRUCTIONS
Clean your countertop and position the cutout template on it as desired. Using a pencil to draw a line on the countertop along the edge of the cutout template.
Remove protective film from foam sealing strip. Apply the foam seal approximately 1/4 inch from the edge of the sink. Do not stretch foam strip and m a k e s u r e t h e e n d s m e e t seamlessly.
For laminated or wood countertop, drill starter hole and cut along the line traced around the template; for granite, m a r b l e o r o t h e r s o l i d s u r f a c e countertop, your fabricator will cut it accordingly.
WellsSinkware.com
I T ' S A W A T E R T H I N G
Slip the mounting clips over the sink rails and into the holes on the rail (the 1-prong side of the clip should face the sink bowls). Rotate the clips according to the thickness of your countertops (see illustration).
Tighten screws in mounting clips with a phillips screwdriver by hand. Warning: Use of a drill or power screw driver can strip screws!
WE LL S SINKWARE COR P.
916 W. 21 Street
st
Chicago, IL 60608
Phone: (888) 626-0006
Fax: (312) 850-3422 Email: contact@WellsSinkware.com
Loading...