WELLS BLOOMFIELD, LLC
10 Sunnen Dr., St. Louis, MO 63143
telephone: 800-807-8054
fax: 314-781-2714
www.wells-mfg.com
OPERATION MANUAL
for
ELECTRONIC POP-UP TOASTERS
Models T-4C and T-4C 15A
and
BAGEL TOASTERS
201
Model BT-4C
Includes
INSTALLATION
USE & CARE
Model T-4C
IMPORTANT: DO NOT DISCARD THIS MANUAL
This manual is considered to be part of the appliance and is to be given to the OWNER or
MANAGER of the restaurant, or to the person responsible for TRAINING OPERATORS of
this appliance. Additional manuals are available from your WELLS DEALER.
THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS U SING OR
INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any
questions concerning installation, operation or maintenance of this equipment.
p/n 2M-40091 Rev. F M201 100118
LIMITED WARRANTY STATEMENT
Unless otherwise specified, all commercial cooking equipment manufactured by WELLS MFG. CO. is warranted
against defects in materials and workmanship for a period of
one year from the date of original installation or 18 months
from the date of shipment from our factory, whichever
comes first, and is for the benefit of the original purchaser
only.
THIS WARRANTY IS THE COMPLETE AND ONLY WARRANTY, EXPRESSED OR IMPLIED IN LAW OR IN FACT,
INCLUDING BUT NOT LIMITED TO, WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE, AND/OR FOR DIRECT, INDIRECT OR
CONSEQUENTIAL DAMAGES IN CONNECTION WITH
WELLS MFG. CO. PRODUCTS. This warranty is void if it
is determined that, upon inspection by an authorized service
agency, the equipment has been modified, misused, misapplied, improperly installed, or damaged in transit or by fire,
flood or act of God. It also does not apply if the serial nameplate has been removed, or if service is performed by unau-
SERVICE POLICY AND PROCEDURE GUIDE
ADDITIONAL WARRANTY EXCLUSIONS
1. Resetting of safety thermostats, circuit breakers, over
load protectors, and/or fuse replacements are not
covered by this warranty unless warranted conditions
are the cause.
2. All problems due to operation at voltages or phase
other than specified on equipment nameplates are
not covered by this warranty.
Conversion to correct voltage and/or phase must be
the customer’s responsibility.
3. All problems due to electrical connections not made
in accordance with electrical code requirements
and wiring diagrams supplied with the equipment are
not covered by this warranty.
4. Replacement of items subject to normal wear, to
include such items as knobs, light bulbs; and, normal
maintenance functions including adjustments of
thermostats, adjustment of micro switches and
replacement of fuses and indicating lights are not
covered by warranty.
5. Damage to electrical cords and/or plug due to exposure
to excessive heat are not covered by this warranty.
6. Full use, care, and maintenance instructions supplied
with each machine. Noted maintenance and
preventative maintenance items, such as servicing and
thorized personnel. The prices charged by Wells Mfg. Co.
for its products are based upon the limitations in this warranty. Seller’s obligation under this warranty is limited to the
repair of defects without charge by a Wells Mfg. Co. factory
authorized service agency or one of its sub-service agencies. This service will be provided on customer’s premises
for non-portable models. Portable models (a device with a
cord and plug) must be taken or shipped to the closest authorized service agency, transportation charges prepaid, for
service. In addition to restrictions contained in this warranty,
specific limitations are shown in the Service Policy and Procedure Guide. Wells Mfg. Co. authorized service agencies
are located in principal cities. This warranty is valid in the
United States and Canada and void elsewhere. Please
consult your classified telephone directory, your foodservice
equipment dealer or write the Factory Service Department,
Wells Manufacturing Company, 10 Sunnen Dr., St. Louis,
MO 63143, (800) 807-9054, for information and other details
concerning warranty.
cleaning schedules, are customer responsibility. Those
miscellaneous adjustments noted are customer
responsibility. Proper attention to preventative
maintenance and scheduled maintenance procedures
will prolong the life of the appliance.
7. Travel mileage is limited to sixty (60) miles from an
Authorized Service Agency or one of its sub-service
agencies.
8. All labor shall be performed during regular working
hours. Overtime premium will be charged to the buyer.
9. All genuine Wells replacement parts are warranted for
ninety (90) days from date of purchase on nonwarranty equipment. This parts warranty is limited only
to replacement of the defective part(s). Any use of
non-genuine Wells parts completely voids any
warranty.
10. Installation, labor, and job check-outs are not
considered warranty and are thus not covered by this
warranty.
11. Charges incurred by delays, waiting time or operating
restrictions that hinder the service technician’s ability to
perform service are not covered by warranty. This
includes institutional and correctional facilities.
SHIPPING DAMAGE CLAIM PROCEDURE
NOTE: For your protection, please note that equipment in
this shipment was carefully inspected and packaged by
skilled personnel before leaving the factory. Upon acceptance of this shipment, the transportation company assumes
full responsibility for its safe delivery.
IF SHIPMENT ARRIVES DAMAGED:
1. VISIBLE LOSS OR DAMAGE: Be certain that any
visible loss or damage is noted on the freight bill or
express receipt, and that the note of loss or damage is
signed by the delivery person.
2. FILE CLAIM FOR DAMAGE IMMEDIATELY:
Regardless of the extent of the damage.
3. CONCEALED LOSS OR DAMAGE: if damage is
unnoticed until the merchandise is unpacked, notify the
transportation company or carrier immediately, and file
“CONCEALED DAMAGE” claim with them. This
should be done within fifteen (15) days from the date
the delivery was made to you. Be sure to retain the
container for inspection.
Wells Manufacturing cannot assume liability for damage or
loss incurred in transit. We will, however, at your request,
supply you with the necessary documents to support your
claim.
xi
2M-40091-201 POP-UP TOASTERS OP MANUAL
TABLE OF CONTENTS
WARRANTY xi
SPECIFICATIONS 1
FEATURES & OPERATING CONTROLS 2
PRECAUTIONS &GENERAL INFORMATION 3
AGENCY APPROVAL INFORMATION 3
INSTALLATION 4
OPERATION 5
CLEANING INSTRUCTIONS 6
TROUBLESHOOTING 7
EXPLODED VIEW & PARTS LIST 8-11
PARTS & SERVICE 13
CUSTOMER SERVICE DATA 13
Thank You for purchasing this
Wells Manufacturing Co.
Electronic Pop-Up Toaster.
Proper installation, professional
operation and consistent
maintenance of this equipment
will ensure that it gives you the
very best performance and a long,
economical service life.
This manual contains the
information needed to properly
install this equipment, and to use
and care for the equipment in a
manner which will ensure its
optimum performance.
SPECIFICATIONS
DIMENSIONS:
Cabinet 12”H x 13-1/8”W x 9-1/16”D
Bread Slot 1-1/8” x 5-1/4”
Slices per Load 1 to 4
ELECTRICAL:
MODEL VOLTS AMPS kW PLUG
T-4C 208V 11.5A 2.4 kW NEMA 6-15P
240V 10.0A 2.4 kW NEMA 6-15P
T-4C 15A 120V 15.0A 1.8 kW NEMA 5-15P
BT-4C 120V 13.3A 1.6 kW NEMA 5-15P
2M-40091-201 POP-UP TOASTERS OP MANUAL
1
FEATURES & OPERATING CONTROLS
SLIDE
KNOBS
(1 per 2
slots,
2 total)
DARKNESS
CONTROL
KNOBS
(1 per 2
slots,
2 total)
CRUMB
TRAY
Fig. 1 Toaster Features & Operating Controls
BRE AD SLOTS
(4 total)
ELEMENTS
(2 per slot,
8 total)
CARRY
HANDLES
(1 each side)
POW ER
CORD
BREAD GUIDES
(2 per slot,
8 tot al)
SLIDE
RACKS
(1 per 2
slots,
2 total)
INTERNAL COMPONENTS
n BREAD SLOTS One to four pieces of bread, one slice of bread per slot.
Oversized to accept Texas toast, English muffin, bagel, etc.
n BREAD GUIDES Hold bread at proper distance from elements
n SLIDE RACKS Carriages hold bread slices for toasting
Controlled by slide knobs
n ELEMENTS Provide toasting heat.
Note: Bagel toaster BT-4C toasts one side (cut side) only
One element in each pair is inert
n DARKNESS Individually adjustable from very light to very dark
CONTROL Control time slide rack is down and elements are energized
KNOBS Each knob controls one pair of bread slots
n SLIDE KNOBS Control slide racks. Initiate toasting timer when pushed
down. Each knob controls one slide rack (one pair of bread
slots)
n POWER CORD Plugs into appropriate electrical receptacle
n CARRY HANDLES Carry the toaster here
DO NOT carry the toaster by the bread slots!
n CRUMB TRAY Crumbs accumulate here. Remove to dump crumbs
2M-40091-201 POP-UP TOASTERS OP MANUAL
2
PRECAUTIONS AND GENERAL INFORMATION
This appliance is intended for use in commercial establishments
only.
This appliance is intended
No other use is
agents.
Operators of this appliance must be familiar with the appliance use,
limitations and associated restrictions. Operating instructions must be
read and understood by all persons using or installing this appliance.
Cleanliness of this appliance is essential to good sanitation. Read and
follow all included cleaning instructions and schedules to ensure the
safety of the food product.
Unplug or disconnect the toaster from electrical power before
performing any maintenance or servicing.
DO NOT submerge toaster in water. DO NOT splash or pour
water into bread slots, controls, control panel or wiring.
DO NOT lift or carry the toaster by the bread slots. Lift and carry
by the carrying handles only.
The technical content of this manual, including any wiring diagrams,
schematics, parts breakdown illustrations and/or adjustment
procedures, is intended for use by qualified technical personnel.
Any procedure which requires the use of tools must be performed by a
qualified technician.
This manual is considered to be a permanent part of the appliance.
This manual and all supplied instructions, diagrams, schematics, parts
breakdown illustrations, notices and labels must remain with the
appliance if it is sold or moved to another location.
This appliance is made in the USA. Unless otherwise noted, this
appliance has American sizes on all hardware.
This unit complies with NSF standard 4 only if maintained and
recommended or authorized by the manufacturer or its
to prepare food for human consumption.
WARNING:
Electric
Shock hazard
All servicing requiring
access to non-insulated
electrical components
must be performed by a
qualified technician.
DO NOT open any
access panel which
requires the use of tools.
Failure to follow this
warning can result in severe electrical shock.
CAUTION:
Risk of
Damage
DO NOT connect and/or
energize this appliance
until all installation
instructions are read and
followed. Damage to the
appliance will result if
these instructions are not
followed.
operated per the instructions in this manual.
This unit is Underwriters Laboratory listed under E6070.
2M-40091-201 POP-UP TOASTERS OP MANUAL
STD 4
E6070
AGENCY APPROVAL INFORMA TION
3