Wells RWN-36 Installation Manual

ELECTRICAL

RWN-36 RWN-36

ALL MODELS WITH A 'T' SUFFIX HAVE THE SAME ELECTRICAL SPECIFICATIONS AS THE STANDARD VERSIONS.

FRONT PANEL CUTOUT

208 240RWN-36

19 1/8

(486)

1350120 1014 1350

30 1/8

(765)

11.3

4.9

SINGLE SINGLE5.6

(381)

20 1/4

(514)

FIELD WIRINGPHASEAMPSWATTSVOLTSMODEL GAUGE

14 AWB CuSINGLE 14 AWB CU

PRODUCT DIMENSIONSCUTOUT DETAILS

5 5/8 (143)

TEMP.

RATING

26 1/2

(673)

90°C 90°C 90°C14 AWB Cu

INSTALLATION INSTRUCTIONS

BUILT-IN NARROW DRAWER WARMERS

MODELS RWN-36 (T)

INCHES

(MM)

19 5/8

(498)

CLEARANCES

THERE ARE NO CLEARANCE REQUIREMENTS FOR THIS UNIT.

INSTALLATION INSTRUCTIONS

INSTALLER MUST MEET CONDITIONS OF ACCEPTABILITY OUTLINED BELOW UPON INSTALLATION:

TO FABRICATE:

1. Layout front panel cutout dimensions and cutout hole in counter front panel.

2. Position attaching flange (supplied) in hole cutout to determine screw hole location. Drill holes using #34 drill.

3. Attach flange to front panel using #6 screws provided.

4. Fabricate rails and rear support in locations shown. TO INSTALL:

1. For ease of installation, remove drawers from unit.

2. Slide unit through front panel opening until rear of unit engages rear support.

3. Remove upper control knob and upper control panel.

4. Install #8-32 speednuts on attaching flange, secure attaching flange to front panel, then secure unit to attaching flange using #8-32 flathead screws provided.

5. Connect service leads to the unit including ground wire.

6. Replace control panel and control knob.

7. Replace drawer.

31 1/8

(791)

26 1/2

(673)

RAILS FLUSH TO BOTTOM OF CUTOUT

REAR SUPPORT

FROM OUTSIDES OF RAILS

(381)

REAR SUPPORT

29 3/4

(756)

WELLS/BLOOMFIELD * VERDI, NV

49340-3 REV (-)