Wells HRCP-7200SLST User Manual

Job Item No.

Over 90 Years Of Quality Foodservice
Products And Service

Model HRCP-7300SLST

DESCRIPTION

Wells Dual Temperature, Slim Line with Slope Top Hot &
Refrigerated Drop-In Cold Pans are two units in one; from a

heated Bain Marie to a refrigerated cold pan with the ip of a

switch. All models are completely self-contained in two, three
and four-well models are CFC free. Pans are recessed 3” to
comply with NSF-7 performance requirements. Designed for
narrow counters.

SPECIFICATIONS

Exterior – One-piece top ange and coved-corner interiors

constructed of 18 gauge stainless steel. Exterior body

constructed of heavy gauge, corrosion resistant steel.

Condensing unit mounted on corrosion resistant frame below
the cold pan.

Interior –CFC free foamed-in-place insulation through-out,
1” drain located in the center for easy cleaning. Ledge is
recessed 3” to comply with NSF-7 requirements, allowing a
layer of air to insulate food and for pan support.

Refrigeration – Air cooled, 134A and 404A free refrigerant
systems featuring wrapped coil construction on both sides
and bottom. Refrigeration system features sight glass, easy

service valves, dryer/lter and receiver. Condensing unit may
be easily removed for service. Larger compressors speed

refrigeration process.

Slim Line With Slope Top-Dual Temperature

NSF-7 Hot & Refrigerated Cold Pans

o HRCP-7200SLST o HRCP-7300SLST o HRCP-7400SLST

Heating - Automatic water-ll with high-limit protection featuring
a water sensor and solenoid value to maintain proper water
levels. And efcient electric immersion heating system transfers
heat directly to the water while a positive-off thermostat controls
provides adjustable and consistent temperatures. Designed for

wet operation only.

STANDARD FEATURES

o NSF series 7 compliant
o Slim line drop-in design for narrow counters
o Controls located on the operator side (high side of slope)
o Pans are raised in the rear for improved visibility and access

to food products

o Self contained drop-in design
o Hold standard 12” by 20” food pans and fractional sized pans
o Stainless steel top and liner for maximum strength and

durability

o 1” drains for ease of cleaning
o Single control for changing from hot to cold operation.
o Easy access temperature & function control panel attached to

a 24” long exible conduit for optional counter mounting

o Type 134A and 404A
o Fully insulated, CFC free, foamed-in place insulation keeps

food cold while saving energy

o Recessed ledge for pan support and colder, fresher products
o Quick & easy service with sight glass, service valves, lter/

dryer and receiver
o Adaptor bars provided for food pans

OPTIONS & ACCESSORIES

o 5-year compressor warranty
o Perforated bottom strainer plate conveniently holds ice

above drain to prevent clogging

o 6’ extended leads for remote mounting of HRCP control panel
(3’ standard)

o Adaptor bars for fractional sized pans
o Remote on/off switch
o 220/230/240V
o 50 cycle
o Condenser orientation and/or compressor rack location
o Remote models (Includes compressor and condensing units

and up to 20’ leads)

o Remote models without compressors or condensing units
o 2nd year parts & labor warranty

CERTIFICATIONS

CFC free refrigerant

Wells Bloomeld · 10 Sunnen Dr. St. Louis, MO 63143 U.S.A.
Phone : [phone] · Fax [phone]

www.wellsbloomeld.com · Printed in the U.S.A.

Sheet No. WELLHRCPSLST-06/14

NOTE: Specications are subject to change without

notice and are not intended for installation purposes.

See installation instructions prior to installing the unit.

Slim Line With Slope Top-Dual Temperature

INCHES

MM

Over 90 Years Of Quality Foodservice
Products And Service

NSF-7 Hot & Refrigerated Cold Pans

o HRCP-7200SLST o HRCP-7300SLST o HRCP-7400SLST

OTE: Specifications are

N

subject to change without notice
and are not intended for installation
purposes. See installation instructions
prior to installing the unit.

SPECIFICATIONS

OVERALL DIMENSIONS INTERIOR DIMENSIONS CUT OUT DIMENSIONS

Model
Number

HRCP-7200SLST

HRCP-7300SLST

HRCP-7400SLST

Model
Number

HRCP-7200SLST 208/240 1.9/2.5 9.0/10.4 SINGLE *

HRCP-7300SLST 208/240 3.0/4.0 14.4/16.7 SINGLE *

HRCP-7400SLST 208/240 3.8/5.0 18.1/20.8 SINGLE *

OVERALL DIMENSIONS

A

Front to Back

Inches

(MM)

19-1/8

(485)

19-1/8

(485)

19-1/8

(485)

POWER SUPPLY- HOT OPERATION

B

Left to Right

Inches

(MM)

49

(1244)

70-1/2
(1790)

92

(2337)

C
Height
Inches

(MM)

26-1/8

(667)

26-1/8

(667)

26-1/8

(667)

D

Front to Back

Inches

(MM)

43-3/4

(1111)

65-1/4
(1657)

86-3/4
(2203)

VO LTS WAT TS AMPS PHASE POWER

* All model permanently field wired connected. Power supply single phase, 3-wire, 120/208-240V, L2-N 120VAC

E

Left to Right

Inches

(MM)

13-7/8

(353)

13-7/8

(353)

13-7/8

(353)

F

Front to Back

Inches

(MM)

47-3/4

(1213)

69-1/4
(1756)

90-3/4
(2305)

SUPPLY

G

Left to Right

Inches

(MM)

17-7/8

(454)

17-7/8

(454)

17-7/8

(454)

WEIGHTS CARTON DIMENSIONS CRATE SIZE

Model
Number

HRCP-7200SLST

HRCP-7300SLST

HRCP-7400SLST

POWER SUPPLY- REFRIGERATION OPERATION

Model
Number

HRCP-7200SLST 115 1/4 4.9 SINGLE * 134A

HRCP-7300SLST 115 1/3 5.6 SINGLE * 404A

HRCP-7400SLST 115 1/2 6.4 SINGLE * 404A

SHIPPING INFORMATION

SHIPPING

WEIGHT

POUNDS

(KG)

220

(100)

240

(109)

275

(125)

INSTALLED

WEIGHT

POUNDS

(KG)

190
(87)

210
(96)

240

(109)

WIDTH

DEPTH

Inches

Inches

(MM)

(MM)

29

(737)34(864)32(813)

29

(737)48(1220)32(813)

29

(737)62(1575)32(813)

VO LTS HP AMPS PHASE POWER

HEIGHT

Inches

(MM)

SUPPLY

CUBIC

FEET

18.26

25.78

33.3

REFRIGERANT

All HRCP models feature automatic water fill systems and require a water supply connection. Please refer

to the operator’s manual and installation instructions for details.

Due to periodic changes in designs, methods, procedures, policies and regulations, the speci cations contained in this sheet are subject to change without notice. While Wells

exercises good faith efforts to provide information that is accurate, we are not responsible for errors or omissions in information provided or conclusions reached as a result of using the

Wells Bloom eld · 10 Sunnen Dr. St. Louis, MO 63143 U.S.A.
Phone : [phone] · Fax [phone]

www.wellsbloom eld.com · Printed in the U.S.A.

speci cations. By using the information provided, the user assumes all risks in connection with such use.

NOTE: Speci cations are subject to change without

notice and are not intended for installation purposes.

See installation instructions prior to installing the unit.

CUBIC

METERS

0.52

0.73

0.94