Wells B-506 Installation Manual

ELECTRICAL

B-506

240B-506

INSTALLATION INSTRUCTIONS

BUILT-IN CHAR BROILER

MODEL B-506

WATTSVOLTSMODEL

AMPS PER LINE 3 PHASE

L3L2L1

30.030.0

AMPS

SINGLE

PHASE

45.026.026.026.010800

FIELD WIRING GAUGE

3 PHASE 1 PHASE
8 AWG Cu-30.010800208

6 AWG Cu
6 AWG Cu

TEMP.

RATING

90°C
90°C8 AWG Cu

INCH
(MM)

PRODUCT DIMENSIONSCUTOUT DETAILS

36 1/2

(927)

35 3/4

(908)

2 9/16

(65)

4 7/8
(124)

12 3/4

(324)

CLEARANCES

MINIMUM CLEARANCE REQUIRED

FROM UNIT TO THE NEAREST SURFACE*

67

(178)

3

(76)(152)

INSTALLATION INSTRUCTIONS

28 3/4

(730)

FRONTBOTTOMSIDEBACK

5/8

(16)

14

(356)

34 7/8

(386)

29 5/8

(752)

27 3/4

(705)

6 1/4
(159)

BROILER FLANGE

GASKET

COUNTERTOP

1/4

(6)

METAL SHIELD
2 3/4

(70)

29 9/16

(751)

WELLSLOK

SCREWDRIVER

11

(279)

6

(152)

2 5/8

(67)

UNIT MUST BE INSTALLED IN AN ALL METAL COUNTER

THE INSTALLATION OF RECOGNIZED COMPONENT UNITS REQUIRES
ADDITIONAL EVALUATIONS TO UNDERWRITERS LABORATORIES
STANDARDS.

INSTALLER MUST MEET CONDITIONS OF ACCEPTABILITY OUTLINED
BELOW UPON INSTALLATION:

1. This appliance must be installed in an all metal counter with suitable
wiring and control enclosures conforming to national and local electrical
codes.

2. Electrical component temperatures, including wiring, within and
surrounding the appliance must be monitored in the end use installation
for suitability.

3. Electrical grounding of all dead metal parts must be reliably
connected to the grounding means of the appliance and must comply with
requirements outlined in the appropriate Underwriters Laboratories Inc.
classification, national and local electrical codes.

4. Increased clearances are required if storage of combustible materials
is in close proximity to this appliance.

5. Unit shall be accessible for servicing from bottom.

6. The name/rating plate information shall be accessible.

TO FABRICATE AND INSTALL:

1. Lay out cutout dimensions on countertop and control
apron as shown in cutout details.

2. Cut and/or drill holes as required in countertop and apron.
NOTE: If stiffener is used around perimeter of countertop
cut-out, total thickness of stiffener plus countertop cannot
exceed 3/16". Also, make certain stiffener design does not
interfere with operation of ears on Wellslok flange,

3. Place gasket on underside of broiler flange. Apply a bead
of silicone sealant to underside of gasket.

4. Locate broiler near countertop cutout. Pass control panel
through countertop cutout and bring it through control panel
cutout on apron. Seat broiler into counter.

5. From underneath, insert screwdriver into slots on patented
Wellslok frame and twist ears clockwise to secure flange
tightly to countertop.

6. Mount control box to apron using screws supplied. Mount
control panel to control box.

NOTE: INSTALLATION MUST MEET LOCAL AND NATIONAL

ELECTRICAL CODES.

WELLS/BLOOMFIELD * VERDI, NV

37116-1 REV (-)