Page 1
23068 FRYER OIL WAND
Wells p/n 23068 Fryer Oil Wand is used as a convenient
method of cleaning the sides of the frypot during filtering, and
for draining oil from the fryer for disposal.
The wand connects to the fryer with a positive shut-off
quick-disconnect fitting. The wand is powered by the fryer’s
filter pump, and draws oil from the filter reservoir.
370
DANGER:
BURN HAZARD
Contact with hot oil will cause
severe burns.
Always wear protective clothing
and heat resistant gloves when
operating the fryer, filtering the
oil or using the oil wand.
IMPORTANT:
Press the FRYER-OFF-FILTER
switch to the OFF position before
inserting or removing the wand.
PRINTED IN UNITED STATES OF AMERICA
Page 1 of 6
p/n 304804 Rev. A ECN-12731 M370 040806 cps
Page 2
FILTERING OIL
DANGER:
BURN HAZARD
Contact with hot oil will cause
severe burns.
Always wear protective clothing
and heat resistant gloves when
filtering the oil.
WARNING:
ELECTRIC SHOCK
All servicing requiring access to
non-insulated components must
be performed by qualified service
personnel. DO NOT open any
access panel that requires the
use of tools. Failure to heed this
warning may result in severe
electric shock.
IMPORTANT:
Be sure the 3-way valve in the
left-right position before pressing
the FRYER-OFF-FILTER switch
to the FILTER position.
HAZARD
FILTERING OIL - NORMAL OPERATION
1. Prepare the filter reservoir pan for filtering.
2. Turn the DRAIN VALVE HANDLE down to
open the drain and fill the filter reservoir.
3. Be sure the 3-WAY VALVE HANDLE is in the left-right position
to direct the pump output to the frypot.
4. Press the FRYER-OFF-FILTER switch to the FILTER position.
5. Filter as per instructions described in Fryer Operation Manual.
NOTE:
If the FRYER-OFF-FILTER switch is pressed to the FILTER
position with the 3-way valve handle in the front-to-back position
(wand not installed), the filter pump will stall and then trip on the
internal safety. To reset:
1. Turn the 3-way valve to the left-right
position.
2. Press the FRYER-OFF-FILTER
switch to the OFF position.
3. Wait approximately 3 minutes for
the motor to cool.
4. Press the red reset button on the
front end of the filter motor until it
“clicks” and locks in.
5. Resume operation.
Page 2 of 6
Page 3
USING THE OIL WAND - WARNINGS AND PRECAUTIONS
DANGER:BURN HAZARD
Contact with hot oil will cause severe burns. Always wear protective clothing and heat
resistant gloves when operating the fryer, filtering the oil or using the oil wand.
WARNING: ELECTRIC SHOCK HAZARD
All servicing requiring access to non-insulated components must be performed by
qualified service personnel. DO NOT open any access panel that requires the use of
tools. Failure to heed this warning may result in severe electric shock.
CAUTION: BURN HAZARD
Contact with hot oil may cause burns.
For disposal of oil use only a container specifically designed for the disposal of hot oil.
DO NOT fill hot oil disposal container beyond MAX OIL line.
DO NOT
fill fryer beyond
MAX OIL
line on frypot.
PRECAUTIONS AND GENERAL INFORMATION
The fryer oil wand accessory attachment is intended for use only
with Wells Mfg. Co. floor-standing fryers equipped with wand
attachment provisions.
The fryer oil wand accessory attachment is intended for use only
in commercial establishments where all operators are familiar
with its use, limitations and associated hazards.
Operator Instructions, including all warnings and precautions,
must be read and understood by all operators and users of this
fryer oil wand accessory attachment prior to use.
The fryer oil wand accessory attachment is designed and
intended for use to wash down the sides of the frypot of the fryer
to which the wand is attached, or to pump oil from that fryer into
a suitable hot oil disposal container. No other use of this fryer
oil wand accessory attachment is intended or authorized by
Wells Manufacturing Co. or its agents.
NOTE: This Operator Instruction is
considered to be a part of the fryer
appliance, and must remain with
the appliance if it is sold or moved
to a different location.
Page 3 of 6
Page 4
USING THE OIL WAND
DANGER:
Contact with hot oil will cause
severe burns.
Always wear protective clothing
and heat resistant gloves when
using the oil wand.
IMPORTANT:
Be sure the wand is properly
installed, and that the discharge
nozzle of the oil wand is directed
either into the frypot, or into a
suitable hot oil disposal container,
before pressing the
FILTER
position.
BURN HAZARD
FRYER-OFF-
switch to the FILTER
CAUTION: BURN
HAZARD
Contact with hot oil may cause
burns. DO NOT fill fryer beyond
MAX OIL line on frypot.
For disposal of oil, use only a
container specifically designed
for the disposal of hot
DO NOT fill hot oil disposal
container beyond MAX OIL line.
NOTE:
If the discharge from the nozzle is
not a steady stream, the filter is
clogged with breading and/or filter
powder:
a. Close the frypot drain valve
by turning the drain valve
handle to the up position.
When all oil is returned to
the frypot press the
FRYER-OFF-FILTER switch
to OFF.
b. Allow the filter reservoir to
cool. Refer to the Operation
Manual for instructions on
cleaning the filter and filter
reservoir.
oil.
USING THE OIL WAND - WASH OUT FRYPOT or DISCARD OIL
1. If discarding oil, be sure a suitable hot oil disposal container
is available. Otherwise, prepare the filter reservoir pan for
filtering.
2. Turn the DRAIN VALVE HANDLE down to open the drain and
fill the filter reservoir.
3. Insert the wand fitting into the fryer fitting:
a. Slide the locking ring of the wand fitting fully toward the
hose.
b. Insert the wand fitting fully into the fryer fitting.
c. Allow the locking ring to spring forward.
d. Check to verify that the wand fitting is held securely by
pulling on the hose.
4. Turn the 3-WAY VALVE HANDLE clockwise to the front-to-rear
position to direct the pump output to the oil wand.
5. Direct the discharge nozzle of the oil wand into the frypot, or
into a suitable hot oil disposal container. DO NOT fill beyond
the MAX OIL line.
6. Press the FRYER-OFF-FILTER switch to the FILTER position.
7. Wand may be used to wash down the sides of the frypot during
filtering, or to pump oil into a container for disposal.
8. At conclusion of use, press the FRYER-OFF-FILTER switch to
the OFF position, disconnect wand from fryer fitting and return
the handle of the 3-way valve to the left-right position.
9. Drain any remaining oil in the wand by pointing the discharge
nozzle of the wand down into the frypot or disposal container.
Page 4 of 6
Page 5
RETURN TO NORMAL OPERATION
RETURN FRYER TO NORMAL OPERATION AFTER USING THE
OIL WAND
1. After washing down the frypot, turn the DRAIN VALVE
HANDLE up to close the frypot drain.
IMPORTANT: Drain handle must be fully closed in order to
activate the heater safety switch. The drain handle must be
in the fully “up” position before fryer heating element can be
energized.
2. Be sure the 3-WAY VALVE HANDLE is returned to the
left-right position.
Press the FRYER-OFF-FILTER switch to the FILTER position.
When all oil has been returned to the frypot, press the
FRYER-OFF-FILTER switch to the FRYER position to resume
operation, or to the OFF position to shut down.
DANGER:
BURN HAZARD
Contact with hot oil will cause
severe burns.
Always wear protective clothing
and heat resistant gloves when
operating the fryer.
CAUTION: BURN
HAZARD
Overflow of hot oil may cause
burns. DO NOT fill fryer beyond
MAX OIL line on frypot.
IMPORTANT:
When refilling the frypot, be
sure the 3-way valve handle is
left-right, and the drain valve
handle is up before pressing the
FRYER-OFF-FILTER switch to
the FILTER position.
Page 5 of 6
Page 6
PRINTED IN UNITED STATES OF AMERICA
Page 6 of 6
Loading...