Wells 22957 Installation Manual

WELLS MANUFACTURING COMPANY
2 ERIK CIRCLE, P. O. Box 280
Verdi, NV 89439
telephone: 775-689-5700
fax: 888-492-2783
www.wellsbloomfield.com
ASSEMBLY, INSTALLATION & CLEANING INSTRUCTIONS
20957, 20958 & 20959
SNEEZE GUARD for HOT DOG ROLLER GRILL
231
ASSEMBLY
1. Remove components from package. Remove protective wrap from plastic parts.
2. Set up end panels with base offsets facing each other. Insert
NOTE: Determine whether to use the blocker panel or the pass-thru panel for the back of
the sneeze guard. either the blocker panel or the pass-thru panel in the rear holes of the side panels.
3. Insert the pass-thru panel in the front holes of the side panels.
4. Loosen 4 side screws in the top panel rails. Slide the top rails over the side panels. Tighten the screws.
5. Set the assembled sneeze guard on the hot dog roller grill. The side panel rails will fit over the side portions of the grill.
Page 1 of 2
p/n 306084 Rev. (-) ECN-12568 I 231 100803 cps
231
CLEANING INSTRUCTIONS
SNEEZE GUARD MODELS 22957, 22958, 22959
CLEANING
1. Carefully remove sneeze guard from hot dog grille.
2. Clean with warm water and mild soap or detergent applied with a soft cotton cloth.
3. Rinse thoroughly with clean water.
4. Dry with a soft cotton cloth or chamois to prevent water spotting.
5. Carefully set sneeze guard back on grille.
IMPORTANT
In order to maintain clarity of plastic parts, DO NOT use: Abrasive Cleansers Petroleum-Based Cleaners Paper Towels Sponges Scouring pads
DO NOT use scrapers or other sharp objects to clean the sneeze guard plastic or metal parts.
DO NOT use chlorinated or alkaline cleansers to clean the sneeze guard.
DO NOT use plastic polish on the sneeze guard. Plastic polishes are not approved for use on food preparation equipment.
Page 2 of 2
p/n 306084 Rev. (-) ECN-12568 I 231 100803 cps
Loading...