P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
SAFETY PRECAUTIONS
http://www.gmpopcorn.com Page 2
P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
GENERAL INSTRUCTIONS
INSPECTION OF SHIPMENT
Unpack all cartons and check thoroughly for any damage that may have occurred during transit. Damage
claims should be filed immediately with the transportation company.
SETUP
Your new Popper was assembled and tested at the factory. Remove all packing material and tape before
starting operation.
Your electrician must furnish sufficient power for proper machine operation. We recommend this popper
be on a dedicated and protected circuit. Failure to wire properly will void the warranty and may result in
damage to the machine.
It is Gold Medal® Products Company’s recommendation that this machine be plugged directly into a wall
outlet. The use of extension cords is not recommended. This may cause sacrificed and/or reduced
performance and can become a safety hazard.
BEFORE YOU PLUG IN THE MACHINE
1. Make sure the wall outlet can accept the grounded plugs (where applicable) on the power supply
cord.
2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect
the outlet and correct if necessary.
3. DO NOT use a grounded to un-grounded receptacle adapter.
http://www.gmpopcorn.com Page 3
P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
OPERATING INSTRUCTIONS
CONTROLS AND THEIR FUNCTIONS
LIGHT AND WARMER SWITCH: Turns on the heat to the bottom corn pan and heat light.
KETTLE MOTOR SWITCH: Turns on the motor which drives the kettle agitator.
KETTLE HEAT SWITCH:
Kettle Heat Switch
Part No. 42798 (1)
AUTO SHUT OFF
The 1866 and 2656 Models are equipped with an auto shut-off mechanism. If the kettle heat is on with no
product popping for fifteen minutes, the auto shut-off will turn off the kettle heat element and the kettle
heat switch will flash. To pop a new batch of corn, cycle the kettle heat switch off and then back on.
AMOUNT OF POPCORN AND OIL
Your new Popper is equipped with a 6 oz corn measuring cup (Part No. 49049).
Corn charge – 6 oz.
Oil charge – 1.6 to 2.0 oz.
Flavacol – 1 teaspoon
POPPING INSTRUCTIONS
1. Turn Kettle Heat and Kettle Motor switch on.
2. Make a test pop by putting 3 kernels of corn and 1 oz. (30 ml) of oil into the kettle.
3. When the 3 kernels have popped, load the kettle with corn and oil charge.
4. When corn has popped, dump the kettle.
5. Repeat cycle starting with step number 3 above; always pop 3-5 batches for best popcorn.
Supplies power to the thermostat controlled kettle
Switch Box Label
Part No. 48502 (1)
Kettle Motor Switch
Part No. 42532 (2)
Light And Warmer Switch
Part No. 42532 (2)
http://www.gmpopcorn.com Page 4
P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
CARE AND CLEANING
KETTLE
1. Each time you finish a series of popping, allow the kettle to cool down and wipe the outside of the
kettle with a soft cloth to remove any oil drippings left behind.
2. After you finish popping for the day, allow the kettle to cool until it is not too hot to handle, but
still warm.
3. Unplug the kettle and remove it from the machine.
4. With a cloth, wipe out the inside of the kettle, kettle lid, crossbar, outside and underneath of the
kettle.
NOTE: DO NOT place the kettle in water. This will cause damage to the electrical components and will
void your warranty.
CABINET
Cleaning the cabinet of your machine is easy. Take a clean cloth and wipe excess grease from the glass.
Wipe the outside of the machine also.
NOTE: Never use a glass or plastic cleaner that contains ammonia. It will crack the plastic on the machine.
http://www.gmpopcorn.com Page 5
P-60/60 Special Model No. 1866, 1866XJ, 2085, 2086, 2656, 2656KC
MAINTENANCE INSTRUCTIONS
http://www.gmpopcorn.com Page 6
Loading...
+ 12 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.