Welite LMT1009 User Manual

OPERATION MANUAL

LMT-1009 Transmitter & LMR-400 Receiver

FEATURES:

● Simple installation, easy operation

● 67 million codes, self program.

● 6 memory scene settings, no memory loss forever.

● Red LED indicator on transmitter.

● Control 2 lights (main and secondary light)

● Can be controlled by transmitter and or existing house hold mechanical switch.

● Security mode.

Main [I] “ON” Button

Main [I] “OFF” Button

Fig. 1

Secondary [II]“ON” Button

Secondary [II] “OFF” Button

“DELAY OFF” Button

Fig. 2 Fig. 3 Fig. 4

ON OFF ON OFF ON OFF
[I] [I] [II] [II] [I]+[II] [I]+[II]

INSTALLATION:
Receiver LMR-400 (Refer to Fig. 1)

z Disconnect main power before installation.
z Connect AC wire (Live & Neutral) to receiver block terminal IN.
z Connect Load wires into receiver block terminal OUT (Port I & Port II) .
z Connect main power on.

OPERATION :

1. Transmitter LMT-1009
(Refer to Fig. 2)

z Main [I] “ON” button: Turns on main [I] light
z Main [I] “OFF” button: Turns off main [I] light

(Refer to Fig. 3)

z Secondary [II] “ON” button: Turns on main [II] light
z Secondary [II] “OFF” button: Turns off main [II] light

z “DELAY OFF” button: Turns off automatically after 10 seconds.
z “Security mode”: Randomly turns on & off the lights.

To activate, hold both “ON and OFF” button of Main [I] for 3 seconds.
To deactivate, simply press any button on the transmitter.

※REMARK※

In order to operate with a transmitter, the mechanical switch must be powered “ON”

2. Mechanical Switch (Refer to Fig. 4)

st

z 1

time “ON” will control the main [I] light

nd

z 2
z 3

HOW TO LINK CODE:

z To start, program transmitter with receiver.
z Connect power to receiver
z Switch ON first then OFF and ON cycle for 6 times, this will enter learning mode.

z Then on transmitter press the main [I] “ON” button once, main [I] and secondary [II] light will flash 2 times to indicate

！

time “ON” will control the secondary [II] light

rd

time “ON” will control both main [I] and secondary [II] light.

While in learning mode, the main [I] light connected to receiver will flash to indicate ready for programming.

programming is confirmed and completed.

During leaning mode if within 12 seconds no signal is detected it will automatically return to stand-by

mode.