WEITECH WK-0062 User Manual [ru]

BIRD LAZZZER

- Power-supply cable

- Directions for use

ENGLISH DIRECTIONS FOR USE

DIRECTIONS FOR USE

Thank you for choosing this Weitech product. For your own safety, and to obtain best results
from this appliance, please read these instructions carefully before using your appliance.

FEATURES

This appliance will not produce any radio interference. It meets all national and European
requirements. Full compliance has been ensured, and the necessary declarations and
documents have been submitted by the manufacturer.

- This appliance has been designed to create lighting effects that will scare birds off,
and pigeons in particular.

- Produces a green-colour laser beam, with a variety of preprogrammed movements.

- The appliance does not require adjusting or setting: it operates automatically to a

15-minute cycle. (15 minutes in operation – 15 minutes at rest, and so on).

BEFORE USE

- Before using the appliance, check that it has not suffered any damage in transit. If
it is damaged, do not use the appliance, and please contact your vendor.

- Important: This appliance left our factory in perfect condition and properly packed. It
is essential that the user should follow safety instructions and warnings given in this
manual. The guarantee is invalid in the event of damage caused by inappropriate
use. The vendor will accept no liability for defects or problems arising as a result of
failure to heed warnings given in this manual.

- Keep this manual in a safe place for future consultation. If you sell the appliance,
ensure that it is sold complete with the manual.

Check the contents:

- One BIRD LAZZZER appliance

- Two keys (for the key-operated switch)

SAFETY INSTRUCTIONS:

NOTE: In order to minimise the risk of electrocution, never remove the lid from the appliance.
There are no components inside the appliance that can be replaced by yourself. Servicing
and maintenance are to be carried out only by qualified technicians.

An arrow inside a triangle warns the user of high voltage, without insulation, inside the
appliance, which can mean a risk of electrocution.

An exclamation mark inside a triangle advises you there are instructions relating to operation
and maintenance to be found in the manual supplied with the appliance.

This symbol means: for use indoors only.

This symbol means: read the directions for use

This symbol represents the minimum retreating distance to be observed, in other words the
minimum distance between the projector and the area to be illuminated. This distance must
be greater than 1 m etre.

- In order to protect the environment, please recycle packaging whenever possible.

- A new light effect can produce unwanted smoke and/or odours, which will normally

disappear after a few minutes’ use.

- In order to prevent any fire risk or electrical discharge, do not expose the appliance
to rain or high humidity.

- To prevent the formation of condensation inside the appliance, give a few minutes
to allow the appliance to adjust to the ambient temperature upon arrival in heated
areas after shipping. Condensation will prevent the appliance from functioning
properly, and may even cause damage.

- This appliance is intended for indoor use only.

- Do not insert any metal objects or pour any liquid inside the appliance. No object

containing any liquid is to be placed on top of the appliance, as this would incur a
risk of triggering an electrical discharge or causing a malfunction. If any foreign
body arrives inside the appliance, immediately disconnect the power supply.

- No naked flames, such as lit candles, must be placed on top of the appliance.

- Place the appliance in a well-ventilated place, well away from any inflammable

materials or liquids. The appliance must be fixed at least 50 cm away from walls.

- Do not cover up air-vents; this would create a danger of overheating.

- Do not use the appliance in a dust-laden environment, and clean it regularly.

BIRD LAZZZER V20062011

- Do not leave the appliance within reach of children.

- Inexperienced persons are not to use the appliance.

- The maximum ambient temperature when using the appliance is 45°C. Do not use

it above this temperature.

- Wall temperatures of the appliance can reach 85°C. Do not touch walls with the
naked hand whilst in operation.

- Ensure that the area under the place of installation does not have any itinerant
persons present whilst installing, dismantling or during maintenance work.

- Allow the appliance to cool down for about 10 minutes before carrying out repairs.

- Always switch the appliance off when not in use for a prolonged period or before

carrying out repairs.

- Electrical installation work should be carried out only by qualified personnel, in
accordance with electrical safety regulations in force in your country.

- Ensure that the electricity supply voltage in your area does not exceed that shown
on the rear of the appliance.

- The supply cable must always be in perfect condition. Turn off the power supply
immediately if the cable is crushed or otherwise damaged. To avoid any risk of
electric shocks, the cable must be replaced by the builder, his agent or a qualified
technician.

- The appliance must be earthed in accordance with standard safety regulations.

- Do not connect the unit to a dimmer switch.

- Always use the suitable certified cables when installing the appliance.

- In order to prevent any electrical discharge, do not open the appliance. There are

no components inside that can be changed by the user.

- Never repair or short-circuit a fuse. Always replace a damaged fuse with a new fuse
of the identical electrical specification.

- In the event of a serious operational problem, shut down the appliance and contact
your retailer immediately.

- The bodywork and lenses must be replaced if they are visibly damaged.

- Use the original packaging if the appliance needs to be shipped.

- It is forbidden for safety reasons to make any modification to the unit that has not

been specially authorised by the parties responsible.

Important: Never gaze directly at the light source! Do not use the
appliance in the presence of epilepsy sufferers.

DANGER: LASER RADIATION!

Avoid exposing the eyes directly to the laser! Laser radiation can

damage the eyes and/or skin. All protection measures are to be

enforced for safety reasons.

- This product emits laser radiation at wavelengths ranging from 400 to 700 nm, and
produces lighting effects intended to scare birds off.

- Light given out by lasers is unlike any other type of light source with which you are
likely to be familiar. The light given out by products of this type can cause damage
to the eyes if it is not controlled and used in an appropriate manner. The light from
a laser beam is thousands of times more concentrated than the light produced by
any other source of light. Such a concentration of light power can cause immediate
and irreversible damage to the eyes, primarily by burning the retina (the area of the
eye that is sensitive to light, located at the rear of the eye socket). Even though one
does not get any sensation of ‘heat’ from a laser beam, it is quite capable of
causing harm to vision, or even blinding, the user or the public.

- Laser beams are potentially dangerous, even at low doses or over long distances.

- So, NEVER gaze at the window through which the laser beam is emitted, nor at the

laser beam itself.

- Never aim the laser beam directly at people or animals, and never leave the
appliance running within reach of the public without supervision.

- This laser may be used only to frighten birds. Use of a class 3B laser is authorised
only when it is operated by qualified and properly trained operators.

- Depending on category, use of a laser can produce radiation that will permanently
damage the eyes and/or skin. Laws on the use of laser products vary from one
country to another. It is for the user to ensure he/she receives good advice, and
that he/she applies the legislation and safety measures in force in his own country.

- The basic documentation and the cornerstone of safety standards relating to laser
beams (ANSI Z136.1-2007) acts as guide in respect of the use of laser beams and
laser-based systems, by laying down control measures for each of the four laser
classes. This useful document can be obtained at website: www.laserinstitute.org

- WEITECH cannot in any circumstances be held liable for any damage caused by
faulty installation and/or non-qualified operators!

LASER SAFETY INSTRUCTIONS:

- According to regulation EN/IEC 60825-1 Ed2, 2007-03, this laser belongs to class
3B. Direct exposure of the eyes to the beam can be hazardous.

BIRD LAZZZER V20062011