Page 1
®
ELECTRIC SALT AND PEPPER
GRINDER SET
USE & CARE MANUAL
SP 0010-2BPT V
1
SP0010-2BPTV_29626_E_IB_A.indd 1SP0010-2BPTV_29626_E_IB_A.indd 1 1/5/23 3:44 PM1/5/23 3:44 PM
Page 2
2
SP0010-2BPTV_29626_E_IB_A.indd 2SP0010-2BPTV_29626_E_IB_A.indd 2 1/5/23 3:44 PM1/5/23 3:44 PM
Page 3
Please Read and Save this Use and Care Book.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always
be followed, including the following:
• Read all instructions.
• Do not immerse the appliance in liquid.
• Store the appliance away from direct sunlight.
• Do not use the appliance for any purpose other than those described in
these instructions.
• Do not leave dead batteries in the appliance, they may leak and cause
damage to the product and surroundings.
• Unless you are using the grinders regularly, it is best to remove the batteries
altogether.
• Do not use different kinds of batteries together (they should all be heavy
duty, all alkaline, etc.).
• Do not put old batteries in a fire or incinerator.
• Do not recharge batteries unless they are specifically designed to be
recharged.
• Do not run the motor for more than one minute to prevent overheating.
• Do not use the mills over food being cooked as moisture from the steam can
clog the grinding mechanism.
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with
the appliance.
SAVE THESE INSTRUCTIONS.
This product is for household use only.
3
SP0010-2BPTV_29626_E_IB_A.indd 3SP0010-2BPTV_29626_E_IB_A.indd 3 1/5/23 3:44 PM1/5/23 3:44 PM
Page 4
4
SP0010-2BPTV_29626_E_IB_A.indd 4SP0010-2BPTV_29626_E_IB_A.indd 4 1/5/23 3:44 PM1/5/23 3:44 PM
Product may vary slightly
from what is illustrated.
Page 5
How to Use
This appliance is for household use only.
GETTING STARTED
• Remove all packing materials and any stickers.
• To register your product, go to www.prodprotect.com/powerxl.
• Clean all parts as instructed in CARE and MAINTENANCE section.
PARTS
1. Switch
2. Battery compartment
3. Batteries 4 x AA (not included)
4. Motor unit
5. Spindle
6. Viewing window
DISMANTLING
• Grip around the body of the motor unit and clear viewing window.
• Turn the cover to move the pointer
• Lift the motor unit o the grinder.
• Remove the battery compartment by grasping around the motor unit top and body
and turning to move the pointer
from lock to unlock .
INSERT BATTERIES
• For maximum performance, always use good quality batteries.
• Fit 4 AA batteries (not included) into each motor unit.
• The polarities ("+" and "-") are marked on the battery
FILL THE GRINDERS
• Ensure you are using grinder quality seasoning.
• Fill the grinders with peppercorns, sea salt, dried herbs or spices.
• Do not overll; this will cause problems during reassembly.
ASSEMBLING
• Ret the motor unit to the grinder by aligning the pointer with the unlock on the
clear viewing window.
• Rotate the motor unit moving it into the lock
• Ret the battery compartment by aligning the pointer
motor unit. Rotate the battery compartment moving it into the lock
ADJUST THE GRIND
• Tip the whole mill upside down and turn the grinder clockwise towards the negative
for a ner grind.
NOTE: Grind will become progressively finer as you rotate the grinder.
• Tip the mill the right way up and press the switch.
• Check the grind size and if required, readjust to suit by turning
clockwise towards the positive
NOTE: Do not turn the knob more than 6 complete rotations clockwise towards the "+". This
may unscrew the knob from the spindle.
• Do the same for the other mill.
.
7. Grinder
8. Bulb connection points
9. Brass connection pins
10. LED Light (not pictured)
11. Clear coasters (not pictured)
from lock to unlock .
compartment.
position.
with the unlock on the
position.
the grinder counter-
5
SP0010-2BPTV_29626_E_IB_A.indd 5SP0010-2BPTV_29626_E_IB_A.indd 5 1/5/23 3:44 PM1/5/23 3:44 PM
Page 6
USING THE MILLS
• Hold the mill directly over food to be seasoned and press the switch. The motor will
run while the switch is pressed and the light will illuminate.
• Release the switch to stop the motor.
CARE AND MAINTENANCE
• Wipe the outside of the mills with a slightly dampened cloth.
• Wipe any excess seasoning from the underside of the grinders with a dry cloth.
• Check that the light bulb connection points and brass connection pins are clean and
clear of any seasoning. Clean with a coarse brush or steel wool, and dust o
afterwards.
• Do not use the mills over cooking as moisture from the steam can clog the grinding
mechanism.
• If the seasoning becomes damp and/or the mechanism becomes clogged,
completely empty the grinder, rotate the grinder to the plus position and wash
the lower chamber in warm water. A mild dish washing detergent may be used. Do
not wash the motor unit.
• Allow the grinder to dry completely before relling and reassembling.
BAT T E RIES
• Check that the batteries are tted correctly - there is a guide inside the battery
compartment.
• When you need new batteries, change them all. Do not use new and used batteries
together.
• Ensure that you use the same battery type together i.e. alkaline or heavy duty.
• Do not leave batteries tted in the mills if they are not used regularly. The batteries
may leak and damage the mills.
• Only recharge batteries that are specically designed to be recharged.
• Close the lid.
6
SP0010-2BPTV_29626_E_IB_A.indd 6SP0010-2BPTV_29626_E_IB_A.indd 6 1/5/23 3:44 PM1/5/23 3:44 PM
Page 7
WARRANTY AND CUSTOMER
SERVICE INFORMATION
TWO-Year Limited Warranty
(Applies only in the United States and Canada)
For service, repair or any questions regarding your appliance, please call our Customer Service
Line at 1-800-577-1557. Please DO NOT return the product to the place of purchase. Also,
please DO NOT mail product back to manufacturer, nor bring it to a service center. You may
also want to consult www.prodprotect.com/powerxl.
What does it cover?
• Any defect in material or workmanship provided; however, the liability of Empower
Brands, LLC will not exceed the purchase price of product.
How long is the warranty valid?
• Two years from the date of original purchase with proof of purchase.
What will we do to help you?
• Provide you with a reasonably similar replacement product that is either new or factory
refurbished.
How do you get service?
• Save your receipt as proof of date of sale.
• Visit the online service website at www.prodprotect.com/powerxl, or call toll-free
1-800-577-1557, for general warranty service.
• If you need parts or accessories, please call 1-800-738-0245.
What does your warranty not cover?
• Damage from commercial use
• Damage from misuse, abuse or neglect
• Products that have been modied in any way
• Products used or serviced outside the country of purchase
• Glass parts and other accessory items that are packed with the unit
• Shipping and handling costs associated with the replacement of the unit
• Consequential or incidental damages (Please note, however, that some states do not
allow the exclusion or limitation of consequential or incidental damages, so this limitation
may not apply to you.)
How does state law relate to this warranty?
• This warranty gives you specic legal rights. You may also have other rights that vary from
state to state or province to province.
Are there additional warranty exclusions?
This warranty shall not be valid where it is contrary to U.S. and other applicable laws, or
where the warranty would be prohibited under any economic sanctions, export control
laws, embargos, or other restrictive trade measures enforced by the United States or other
applicable jurisdictions. This includes, without limitation, any warranty claims implicating
parties from, or otherwise located in, Cuba, Iran, North Korea, Syria and the disputed Crimea
region.
7
SP0010-2BPTV_29626_E_IB_A.indd 7SP0010-2BPTV_29626_E_IB_A.indd 7 1/5/23 3:44 PM1/5/23 3:44 PM
Page 8
®
Dist. by: Empower Brands, LLC, Middleton, WI 53562
Registered Trademark and TM Trademark of Empower Brands, LLC.
®
©2023 Empower Brands, LLC. All rights reserved.
1/23 29626
Made in China.
T22-9003345-A
8
SP0010-2BPTV_29626_E_IB_A.indd 8SP0010-2BPTV_29626_E_IB_A.indd 8 1/5/23 3:44 PM1/5/23 3:44 PM
Loading...