GoerTek GBH808 Bluetooth Headset User Manual
1 Introduction
The GoerTek GBH808 headset is a wireless headset developed with Bluetooth technology.
GBH808 headset can communicate with other Bluetooth devices such as a mobile phone, PDA, or
PC, etc., within a range of approximately 10 meters (33 feet).
Other Items in the Package
- Please refer to real products. The above pictures are only for your reference.
2 Overview
1- Multi-function Button
Turns on/off the headset, answers calls, ends calls
2- Volume-Increase Button
Increases the volume during conversation
3- Volume-Decrease Button
Decreases the volume during conversation
4- Ear-hook
Wears the headset with the ear-hook
5- Microphone
Transfers sound into an electronic signal
6- Receiver
Transfers electronic transmission into sound
7- Charging Interface
8- Indicator Light
Indicates the state of headset
3 Charging the headset
3.1 Using AC charging adapter:
Charging steps are as follows:
3.1.1 Connect AC charging adapter to USB cable;
3.1.2 Plug the charging adapter into AC outlet, and then plug USB cable into GoerTek GBH808
headset. The red indicator light should turn on when connected.
3.1.3 Headset is fully charged when red indicator light goes out.
3.1.4 Unplug the charging adapter from outlet. Unplug USB cable from headset.
3.2 Using USB cable:
Charging steps are as follows:
3.2.1 Connect USB cable to PC or other devices which could provide USB power.
3.2.2 Plug USB cable to GBH808 headset. The red indicator light should turn on when headset is
connected to power.
3.2.3 Headset is fully charged when red indicator light goes out.
Note: To reduce the charging time, the headset will power off while charging. User can power on
the headset while charging if wanted. If there is any un-convenience while using the product, you
can also reset it by charging.
4 Wearing the headset
The weight of GBH808 is only about 10g. Wearing positions could be adjusted referring to the
following figures.
Adjust the ear-hook angle as shown in the figure below.
- Care should be taken during this process avoiding breaking the headset.
5 Turning On/Off
5.1 Turning the headset ON: Press multi-function button for about 3 seconds until blue light
begins flashing, then release the multifunction button. The headset is switched on.
5.2 Turning the headset OFF: Press the multi-function button for 5 seconds until red light flashes
and headset beeps, then release the button. The headset is switched off.
6 Pairing with a mobile phone
Before using the headset, make sure that the headset is paired to your phone or other Bluetooth
devices.
6.1 Ensure the headset is switched off before pairing.
6.2 Press the MFB for about 5 seconds until red and blue lights flash alternatively, then release.
The headset is now ready for pairing.