Weidmuller IE-CST-2TX User Manual

Serial/Ethernet Converter

IE-CS-2TX-1RS232/485

IE-CST-2TX-1RS232/485

IE-CS-2TX-2RS232/485

IE-CST-2TX-2RS232/485

Hardware Installation Guide

First Edition, April 2011

1243440000/00/04.11

Please note:

This document, the

product information - if available - can be downloaded at

http://www.weidmueller.com/downloads

Æ For manual select <Print Media> then goto

Section <Industrial Ethernet> Æ For SE-Converter Administration Software, Windows Com-Port driver or Firmware Update select <Software> then goto Section <Industrial Ethernet>

Reproduction without permission is prohibited.

detailed manual and any further

the internet link:

1. Overview

The Serial/Ethernet converters from Weidmüller deliver easy and reliable serial-to-Ethernet connectivity for the industrial automation market. The converters support several operation modes - TCP Server, TCP Client, UDP, Real COM, RFC2217, RTelnet, Pair Connection, and Ethernet Modem - ensuring the compatibility of network software, and are an ideal choice for connecting RS-232/422/485 serial devices, such as PLCs, sensors, meters, motors, drives, barcode readers, and operator displays.

2. Package Checklist

Before installing the Serial/Ethernet converter, verify that the package contains the following items:

• 1 Serial/Ethernet Converter

• Documentation and Software CD

Æ Please download CD-ROM content from Internet page http://www.weidmueller.com/downloads Æ For manual select <Print Media> then goto Section <Industrial Ethernet> Æ For Administration Software, Windows Com-Port driver or Firmware Update select <Software> then goto Section <Industrial Ethernet>

• 1 Hardware Installation Guide

If any of these items are missing or damaged, please contact your Weidmüller customer service for assistance.

3. Hardware Introduction

The IE-CS(T)-2TX-1RS232/485 is equipped with one RS-232 DB9 serial port and one RS-422/485 terminal block for serial data communication. The IE-CS(T)-2TX-2RS232/485 is equipped with two RS-232/422/485 3-in-1 DB9 serial ports for serial data communication. Each model has one 8-contact screw-type terminal block, which is located on the top for power input and relay output.

- 2 -

Appearance of the IE-CS(T)-2TX-1RS232/485

Appearance of the IE-CS(T)-2TX-2RS232/485

Reset to factory settings

To load the factory default settings depress the reset button for 5 continuous seconds. Use a pointed object, such as a straightened paper clip or toothpick, to depress the Reset button. This will cause the Ready LED to blink on and off. When the factory default settings are loaded then the Ready LED stops blinking (after about 5 seconds). At this point, you can release the Reset to default button.

- 3 -

+ 5 hidden pages