Weidmuller HS01 User Manual

Weidmuller Ltd.
10 Spy Court
Markham, ON L3R 5H6
Tel: [phone]
Fax: [phone]

Weidmuller Ltd
821 Southlake Blvd.
Richmond, VA 23236 U.S.A.
Tel: [phone]
Fax: [phone]

ISO 9001 Registered

Electronic Interface Modules

Heat Sink, Model HS01

Ultra SlimPak® Series

All Ultra SlimPak (USP) modules are designed and tested
to operate in ambient temperatures from 0 to 55°C,
when mounted on a horizontal rail (see Figure A) or with
approximately 1/2" between modules (see Figure B) to
allow adequate air circulation.

When five or more modules are mounted in close
proximity (see Figure C) or are mounted on a vertical rail
(see Figure D), circulating air or model HS01 Heat Sink is
recommended.

Figure A: Horizontal Rail Mount (recommended)

Figure B: Vertical Rail Mount (circulating air and 1/2” gap, >5 units)

Figure C: Vertical Rail Mount >5 units not recommended)

Figure D: Vertical Rail Mount (circulating air and

Model HS01 Heat Sink, >5 units)

Installation

Specifications

Material
Anodized

Ordering Information

Heat Sink

The HS01 heat sink mounts tightly between Ultra SlimPaks and the DIN mounting rail. Simply fit the HS01
heat sink to the Ultra SlimPak as shown above, then snap both onto the rail together.
To remove the Ultra SlimPak without removing the heat sink or combi-foot from the rail, slide the Ultra
SlimPak up (from the vertical position), approximately 0.75", off the combi-foot and remove the module.

Aluminum Alloy 5052H32, 0.063" thick
Black, MIL-A-8625

Cat.No.

HS01-A

Specifications subject to change without notice. 99990023 - 8/98 Printed in Canada