WEG Electric MPW16 Technical Data
www.weg.net
Controls
Manual Motor Protectors - MPW16 Technical Data
General Ratings
TYPE MPW16-3-C016 MPW16-3-C025 MPW16-3-D004 MPW16-3-C063 MPW16-3-U001 MPW16-3-D016 MPW16-3-D025
Standards Devices according to International Standards IEC 60947-1 / 60947-4-1, European Standards EN 60947-1 / 60947-4-1,
Current Setting Range [A] 0.10 - 0.16 0.16 - 0.25 0.25 - 0.40 0.40 - 0.63 0.63 - 1.0 1.0 - 1.6 1.6 - 2.5
Rated Thermal Current Ith [A] 0.16 0.25 0.40 0.63 1.0 1.6 2.5
Rated Insulation Voltage Ui
Acc. IEC; VDE 0660 [V] 690
Acc. UL; CSA [V] 600
Rated Operating Voltage Ue
Acc. IEC; VDE 0660 [V] 690
Acc. UL; CSA [V] 600
Rated Impulse Voltage Uimp
Acc. IEC60947-1 [kV] 6
Rated Operating Frequency [Hz] 50/60
Overvoltage Category III
Pollution Degree 3
Utilization Category
IEC 60947-2 (Motor Protector) A
IEC 60947-4-1 (Motor Starter) AC-3
Lifespan
Mechanical [ops.] 100,000
Electrical (Ie max.) [ops.] 100,000
Switching Rate (motor starts) AC-3 [ops/hr] 15
Ambient Temperature
Storage [oC (oF)] -50 to +80 (-58 to +176)
Operating [oC (oF)] -20 to +60 (-4 to +140)
Ambient Temperature Compensation [oC (oF)] -20 to +60 (-4 to +140)
Climatic Proofing IEC 60068-2-3 / IEC 60068-2-30
Altitude
Up to 2,000m (6,600ft) Nominal Values (for higher altitudes refer to page 244)
Degree of protection IP20
Resistance to Shock
Acc. IEC 60068-2-27 [g] 15
Resistance to Vibration IEC 68-2
Protection against direct contact
Acc. IEC 536; DIN VDE 0106 Part 100 Finger and back of hand proof
Phase Failure Sensitivity Protection Yes
Overload Protection Characteristics x Iu [A] 0.6 - 1
Magnetic Release x Iu [A] 13
Overload Trip Class 10
Total Power Loss Pv
At rated load operating temperature [W] 6 6 6 6 6 6 6
Weight [kg] 0.30
[lb] 0.70
Type of Terminal Flat Type
Screw Driver Philips #2
Terminal Capacity
Solid [mm2] Refer to table on page 243
Stranded [mm2]
Solid or Stranded [AWG]
Tightening Torque [N.m (lb.in)] 1.2 - 1.7 (11 - 16)
Mounting Position Any Position
Underwriters Laboratories - UL 508; CSA C.22.2/14; VDE 0660/102
CONTROLS
WEG Automation - Products and Solutions 223
www.weg.net
Controls
Manual Motor Protectors - MPW16 Technical Data
General Ratings
TYPE MPW16-3-U004 MPW16-3-D063 MPW16-3-U010 MPW16-3-U016
Standards Devices according to International Standards IEC 60947-1 / 60947-4-1, European Standards EN
Current Setting Range [A] 2.5 - 4.0 4.0 - 6.3 6.3 - 10 10 - 16
Rated Thermal Current Ith [A] 4.0 6.3 10 16
Rated Insulation Voltage Ui
Acc. IEC; VDE 0660 [V] 690
Acc. UL; CSA [V] 600
Rated Operating Voltage Ue
Acc. IEC; VDE 0660 [V] 690
Acc. UL; CSA [V] 600
Rated Impulse Voltage Uimp
Acc. IEC60947-1 [kV] 6
Rated Operating Frequency [Hz] 50/60
Overvoltage Category III
Pollution Degree 3
Utilization Category
IEC 60947-2 (Motor Protector) A
IEC 60947-4-1 (Motor Starter) AC-3
Lifespan
Mechanical [ops.] 100,000
Electrical (Ie max.) [ops.] 100,000
Switching Rate (motor starts) AC-3 [ops/hr] 15
Ambient Temperature
Storage [oC (oF)] -50 to +80 (-58 to +176)
Operating [oC (oF)] -20 to +60 (-4 to +140)
Ambient Temperature Compensation [oC (oF)] -20 to +60 (-4 to +140)
Climatic Proofing IEC 60068-2-3 / IEC 60068-2-30
Altitude
Up to 2,000m (6,600ft) Nominal Values (for higher altitudes refer to page 244)
Degree of protection IP20
Resistance to Shock
Acc. IEC 60068-2-27 [g] 15
Resistance to Vibration IEC 68-2
Protection against direct contact
Acc. IEC 536; DIN VDE 0106 Part 100 Finger and back of hand proof
Phase Failure Sensitivity Protection Yes
Overload Protection Characteristics x Iu [A] 0.6 - 1
Magnetic Release x Iu [A] 12
Overload Trip Class 10
Total Power Loss Pv
At rated load operating temperature [W] 6 6 6 6
Weight [kg] 0.3
CONTROLS
Type of Terminal Flat Type
Screw Driver Philips #2
Terminal Capacity
Solid [mm2] Refer to table on page 243
Stranded [mm2]
Solid or Stranded [AWG]
Tightening Torque Main
Mounting Position Any Position
Circuits
[lb] 0.7
[N.m (lb.
in)]
60947-1 / 60947-4-1, Underwriters Laboratories - UL 508; CSA C.22.2/14; VDE 0660/102
1.2 - 1.7 (11 - 16)
224
1-800-ASK-4WEG
Data is subject to change without notice.
Loading...