Weems & Plath Lxaa-red Owners Manual

All Around (RED) LED Nav Lights

(for Commercial & Military Vessels)

Model: LXAA-RED

OWNER’S MANUAL

Weems & Plath

214 Eastern Avenue • Annapolis, MD 21403

p [phone] • f [phone]

www.Weems-Plath.com/OGM

®

USCG 2NM Approved

33 CFR 183.810 Meets ABYC-A16

INTRODUCTION

Weems & Plath’s OGM LX All Around (RED) LED Navigation Light is designed for
power-driven commerical or military vessels and will provide full brightness
at any operating voltage from 9V to 30V DC. This ensures the light will meet
or exceed the visibility requirements as the battery voltage drops from use. To
ensure compliance with the ‘72 COLREGS and U.S. Inland Rules, the installation
instructions provided below must be followed.

Mounting:

1. There are three 6-32 stainless steel inserts in the bottom of the light’s
housing. This allows the All Around Light to be mounted to a variety of
mounting brackets. *Mounting brackets can be purchased from Weems &

Plath or your local marine retailer.

2. The light should be mounted level and even to insure maximum
visibility of the light.

Wire Color from Pigtail Connection/Function

BLACK Electrical ground/negative battery terminal

BROWN (NOT USED)

BLUE Power for All Around Light

1. Connect the black wire to the boat’s DC ground and the blue wire to the
boat’s DC positive power source. NOTE: DO NOT CONNECT THE BROWN
WIRE. Ensure that the supplied voltage is greater than 8V and less
than 31 V DC. Weems & Plath does not guarantee any light connected
improperly or to an incorrect voltage. Always verify proper DC voltage
before nal connections are made.

2. WARNING: The current draw of the All Around Light is ≤ 0.33 Amps
at 12V DC. The power circuit should include proper fusing or a circuit
breaker with a trip current of 1 Amps.

3. Check the light with a battery after installation is complete to ensure
proper operation.

Wiring:

The All Around (RED) Light is equipped with a 3-conductor waterproof plug.
The mating connector and 2-foot cable are included. Mast wiring of 20-gauge
is sucient to supply power to the light, although 16-gauge is recommended.

There are three wires in the supplied mating yellow/black cable, however
you will only use two wires for the All Around (RED) Light (#LXAA-RED). The
proper connection for these wires is shown in the following diagram:

Quick Disconnect Wiring Diagram

BLACK (Shield)

Ground

BROWN (Black)

NOT USED

BLUE (Red)
All Around

SPECIFICATIONS

Visibility: 2 nautical miles

Waterproof: yes, completely submersible

Power Consumption: 6 Watts

Voltage Range: 9V to 30V DC

Current Draw: ≤ 0.33 Amps at 12V DC

Wiring: 2-conductor 20 AWG UV jacketed 2-foot cable

Horizontal Viewing Angle: 360°

Vertical Viewing Angle: +/- 18°

Warranty:

This product is covered by a LIFETIME Warranty. For more details on the
warranty, please visit: www.Weems-Plath.com/Support/Warranties

To register your product visit: www.Weems-Plath.com/Product-Registration