Weed Eater 530165303-01 User Manual

R Trademark

Instruction Manual

Manual de Instrucciones

Manuel d’Instructions

IMPORTANT MANUAL -- Do not throw away MANUAL IMPORTANTE -- No lo descarte MANUEL IMPORTANT -- À Conserver

ENGLISH

B1750

ESPAÑOL

WARNING:

Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury.

ADVERTENCIA:

Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves.

AVERTISSEMENT:

Veuillez lire le manuel d’instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves.

Electrolux Home Products, Inc. 104 Warren Road Augusta, GA 30907

530165303--01 6/10/04

FRANÇAIS

SAFETY RULES

WARNING: Failure to follow all

Safety Rules and Precautions can result in serious injury.

KNOW YOUR UNIT

S Read your instruction manual carefully until

you completely understand and can follow all warnings and safety rules before operating the unit.

D Restrict unit to users who understand and

will follow all warnings and safety rules in this manual.

WARNING: Inspect area before start-

ing unit. Remove all debris and hard objects such as rocks, glass, wire, etc. that can ricochet, be thrown, or otherwise cause injury or damage during operation.

Use your unit as a blower for:

D Sweeping debris or grass clippings from

driveways, sidewalks, patios, etc.

D Blowing grass clippings, straw, or leaves into

piles, around joints, or between bricks.

PLAN AHEAD

D Always wear eye protection when operat-

ing, servicing, or performing maintenance on unit. Wearing eye protection will help to prevent rocks or debris from being blown or ricocheting into eyes and face which can result in blindness and/or serious injury. Eye protection should be marked Z87.

D Always wear foot protection. Do not go

barefoot or wear sandals.

D Always wear respirator or face mask when

working with unit in dusty environments.

D Secure hair above shoulder length. Secure

or remove jewelry, loose clothing, or clothing with loosely hanging straps, ties, tassels, etc. They can be caught in moving parts.

D Do not operate unit when you are tired, ill, up-

set, or if you are under the influence of alcohol, drugs, or medication.

D Keep children, bystanders, and animals

away from work area a minimum of 30 feet (10 meters) when starting or operating unit. Do not point the blower nozzle in the direction of people or pets.

HANDLE FUEL WITH CAUTION, IT IS HIGHLY FLAMM AB LE

D Eliminate all sources of sparks or flame (in-

cluding smoking, open flames, or work that can cause sparks) in the areas where fuel is mixed, poured, or stored.

D Mix and pour fuel in an outdoor area; store

fuel in a cool, dry, well ventilated place; use an approved, marked container for all fuel purposes.

D Do not smoke while handling fuel or while

operating the unit.

D Make sure the unit is properly assembled

and in good operating condition.

D Do not fill fuel tank while engine is hot or

running.

D Avoid spilling fuel or oil. Wipe up fuel spills

before starting engine.

D Move at least 10 feet (3 meters) away from

fuel and fueling site before starting engine.

D Always store gasoline in a container ap-

proved for flammable liquids.

OPERATE YOUR UNIT SAF ELY

WARNING: This unit is intended for

blower use only. Do not attempt to open inlet cover. Opened or damaged inlet cover can result in serious injury. Discontinue use of blower immediately if inlet cover becomes opened or damaged. Take unit to your nearest authorized service dealer for repair.

D Inspect unit before each use for worn,

loose, missing, or damaged parts. Do not use until unit is in proper working order.

D Keep outside surfaces free of oil and fuel. D Never start or run engine inside a closed

room, building or other unventilated area. Breathing exhaust fumes can kill.

D To avoid static electricity shock, do not

wear rubber gloves or any other insulated gloves while operating unit.

D Do not set unit on any surface except a

clean, hard area while engine is running. Debris such as gravel, sand, dust, grass, etc. could be picked up by the air intake and thrown out through discharge opening, damaging unit, property, or causing serious injury to bystanders or operator.

D Avoid dangerous environments. Do not use

in unventilated areas or where explosive vapors or carbon monoxide build up could be present.

D Do not overreach or use from unstable sur-

faces such as ladders, trees, steep slopes, rooftops, etc. Keep firm footing and balance at all times.

D Never place objects inside the blower

tubes; always direct the blowing debris away frompeople, animals, glass, and solid objects such as trees, automobiles, walls, etc. The force of air can cause rocks, dirt, or sticks to be thrown or to ricochet which can hurt people or animals, break glass, or cause other damage.

D Never run unit without the proper equip-

ment attached. When using your unit as a blower, always install blower tubes.

D Check air intake opening and blower tubes

frequently, always with engine stopped and spark plug disconnected. Keep vents and discharge tubes free of debris which can accumulate and restrict proper air flow.

D Never place any object in the air intake open-

ing as this could restrict proper air flow and cause damage to the unit.

D Never use for spreading chemicals, fertiliz-

ers, orother substances which may contain toxic materials.

D Toavoid spreading fire, do not use near leaf

or brush fires, fireplaces, barbecue pits, ashtrays, etc.

D Use only for jobs explained in this manual.

-- 2 --

MAINTAIN YOUR UNIT PROPERLY

D Have all maintenance other than the rec-

ommended procedures described in the instruction manual performed by an authorized service dealer.

D Disconnect spark plug before performing

maintenance except for carburetor adjustments.

D Use only recommended Weed EaterŽ re-

placement parts; use of any other parts may void your warranty and cause damage to your unit.

D Empty fuel tank before storing the unit. Use

up fuel left in carburetor by starting engine and letting it run until it stops.

D Do not use any accessory or attachment

other than those recommended by manufacturer for use with your unit.

D Do not store the unit or fuel in a closed area

where fuel vapors can reach sparks or an open flame from hot water heaters, electric motors or switches, furnaces, etc.

D Store in a dry area out of reach of children.

SPECIAL NOTICE: Exposure to vibra-

tions through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swelling. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of

ASSEMBLY

WARNING: This unit is intended for

WARNING: If you receive your unit

assembled, check each step to insure your unit is properly assembled and all fasteners are secure. Follow all safety information in the manual and on the unit.

BLOWER TUBE ASSEMBLY

1. Align the rib on the blower tube with the groove in the blower outlet; slide the tube into place.

strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An antivibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool.

SPECIAL NOTICE:For users on U.S. For-

est Land and in some states, including California (Public Resources Codes 4442 and

4443), Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington: Certain internal combustion engines operated on forest, brush, and/orgrass covered land in the above areas are required to be equipped with a spark arresting screen, maintained in effective working order,or the engine must be constructed, equipped, and maintained for the prevention of fire. Check with your state or local authorities for regulations pertaining to these requirements. Failure to follow these requirements is a violation of the law. This unit is not factory equipped with a spark arresting screen; however, a spark arresting screen is available as an optional part. If a spark arresting screen is required in your area, contact your authorized service dealer for the correct kit. The spark arresting screen, blower tubes, and nozzles must be assembled to unit to be in full compliance with regulations.

NOTE: Knob must be loose enough to allow

blower tube to be inserted in blower outlet. Loosen knob by turning counterclockwise.

Blower Outlet

Groove

2. Secure the tube by turning the knob clockwise.

3. To remove the tube, turn the knob counterclockwise to loosen the tube; remove the tube.

Blower Tube

Rib

-- 3 --

+ 7 hidden pages