Page 1
Thermo Top Heater Series Smart Controller
Quick Set-Up Guide
Initial Start-Up
When the Control unit is connected for the first time, a message about the Setting/Configuration of
the heater is displayed.
1 Menu Name
2 Menu Symbols
3 Time Setting Activated
4 Time
5 On / Off Button
6 Control Knob
Timer
Heating
Settings
Press the control knob and the On/Off Button simultaneously for 3 seconds
Select your Heater
Press the Control Knob
Select the current Day
Press the Control Knob
Select the current Time - turn the Control Knob clockwise to select Hour, press the Control Knob
to confirm, then turn the Control Knob clockwise again to select the Minutes, press the Control
Knob to set.
TT‐Z/C/E
HS
Heater
Page 2
If your heater was not selected correctly at Initial Start-Up a Manual Reset is required.
Press the On/Off Button to go to the Main Menu Screen and follow the following steps.
Select the symbol “Settings”
Press the Control Knob
The “Quick Start” menu is displayed
Turn the Control Knob clockwise 10 times until “Reset” is displayed
Select “Reset” by pressing the Control Knob
Press the Control Knob to confirm.
The Control Knob is now restarted
During the restart of the Control Knob, an Hourglass will quickly appear
Press the Control Knob and the On/Off Button simultaneously for 3 seconds
The Control is now ready for use.
Select your Heater (Note: PHEC System is displayed as TT - Z/C/E HS)
Press the Control Knob
Heang
MAX
Duraon
Select “Heating”
Press the Control Knob
Press the Control Knob to select continuous (infinite) running.
(OR To program a Timer at this point turn the Control Knob clockwise to select the time from
10 minutes to 2 hours).
Continuous (Infinite) Running has been selected
Operation
Page 3
PHEC System Heater Smart Controller
Timer Programming
It is possible to program the Timer Setting 7 days in advance. The heater switches on automatically
at the programmed time. Up to 3 time settings per day can be set, with a total of 21 time settings
for the week.
Before the timer can be activated, make sure that the:
Time and current day of the week are set,
Heater is switched off
“Timer” symbol has been selected in the main menu
Press the Control Knob
“Add Timer” screen is displayed
Press the Control Knob in order to add a new timer
Turn the Control Knob to select chosen “Day”
Press the Control Knob to confirm selection
Turn the Control Knob to choose the desired Switch On time (Hour)
Press the Control Knob to confirm
Turn the Control Knob again to choose the Minutes
Press the Control Knob to confirm
Turn the Control Knob to choose the desired Switch OFF time (Hour)
Press the Control Knob to confirm
Turn the Control Knob again to choose the Minutes
Press the Control Knob to confirm
Select the “Heating” operation mode from the Main Menu screen
Page 4
The programmed timer is saved and shown on the display
Press the Control Knob to activate the programmed time
“Activate” message will appear on the display
www.webasto.com.au
07/15 • Errors and omissions excepted • Printed in Australia • © Webasto Thermo & Comfort Australia Pty Ltd
Webasto Thermo & Comfort Australia Pty Ltd
423-427 The Boulevarde
Kirrawee NSW 2232
Australia
Phone: +61 (0)2 8536 4800
Fax: +61 (0)2 8536 4899
info@webasto.com.au
Repeat the process to add timers (3 timer settings per day, 21 per week)
Loading...