
Operating Instructions
Sunroof: Hollandia 300, 500, 600, 700, 710
Doc.-No.: 0912033A
Date: 20-04-2004
Technical Sales Support Webasto International Page 1 of 15
Operating the sunroof
1. Control panels (electric and electronic versions)
Electric versions
Hollandia 300 DeLuxe versions without sliding sunshade
(with or without sunrollo), Hollandia 500 FreeDome
Hollandia 600, Hollandia 300 Classic and
Hollandia 300 DeLuxe versions with sliding
sunshade
Open
Close
Full electronic versions
Hollandia 500 and Hollandia 300 DeLuxe versions without
sliding sunshade, with or without sunrollo
Hollandia 700 and Hollandia 300 DeLuxe
versions with sliding sunshade
Pre-set position 1
Slide close
Pre-set position 2
One touch close
Tilt / slide open
Note: pictures shown in this manual refer to Hollandia 300 DeLuxe Medium, if not stated otherwise. Therefore
minor details in pictures can vary from your sunroof.

Operating Instructions
Sunroof: Hollandia 300, 500, 600, 700, 710
Doc.-No.: 0912033A
Date: 20-04-2004
Technical Sales Support Webasto International Page 2 of 15
2. Operating manual versions
Opening sunroof.
Closing sunroof.

Operating Instructions
Sunroof: Hollandia 300, 500, 600, 700, 710
Doc.-No.: 0912033A
Date: 20-04-2004
Technical Sales Support Webasto International Page 3 of 15
3. Operating electric versions
Switch on ignition.
Maximum tilt position
Maximum sliding position
Press S-button to open sunroof.
Release button when sunroof is in position you
like.

Operating Instructions
Sunroof: Hollandia 300, 500, 600, 700, 710
Doc.-No.: 0912033A
Date: 20-04-2004
Technical Sales Support Webasto International Page 4 of 15
Closing completely.

Operating Instructions
Sunroof: Hollandia 300, 500, 600, 700, 710
Doc.-No.: 0912033A
Date: 20-04-2004
Technical Sales Support Webasto International Page 5 of 15
3. Operating full electronic versions
3.1. Programming the sunroof before using it the first time
Switch on ignition.
Close sunroof completely, release switch, press
again and hold T-button for at least 5 seconds.
Open sunroof completely (therefore briefly press
S-button), a click will indicate end position.
Sunroof is programmed now.