WeatherTech License Plate Frames User Manual

ClearFrame
License Plate Frame Mounting Instructions
TOOLS NEEDED • #2 Phillips Head Screwdriver • 7/16" Wrench
1. Remove the Click and Stay™ screw caps from the mounting holes in the WeatherTech® ClearFrame™ by pushing them out from the back side.
2. Lay the WeatherTech® ClearFrame™ face down on a soft or non-abrasive surface.
3. Position the license plate face down into the protective gasket that is molded into the edge of your ClearFrame™, noting that the ClearFrame™ gasket is marked “BOTTOM” for proper positioning. Make certain that you have a proper fit and seal between the license plate and the ClearFrame™.
4. Select the four mounting screws that are most appropriate for your vehicle (If your mounting location only uses 2 holes, then see step 4A FIRST). Carefully position your ClearFrame™ license plate assembly into place on your vehicle and using a #2 Phillips Head Screwdriver, securely fasten with the screws you have chosen, BEING CAREFUL NOT TO OVER-TIGHTEN.
(4A) If the mounting location on your vehicle only
uses two screws, then first select machine screws and matching nuts from the hardware pack. Install these two screws through the ClearFrame™ license plate assembly in the holes that DO NOT go to the mounting holes on the vehicle. Using a #2 Phillips Head screwdriver and a wrench, tighten the two nuts onto the end of each screw, locking the assembly together, BEING CAREFUL NOT TO OVER-TIGHTEN.
5) Finally, position the Click and Stay™ screw caps over each screw on your ClearFrame™ with the drain hole on the bottom and push firmly to snap each one into place.
HELP!
If you have questions regarding installation of this or any other WeatherTech® product, please call our customer service department at (630) 769-1500, Monday through Friday, 9 a.m. to 5 p.m. Central Time. We want to help you get the most out of your new WeatherTech® product.
CONTENTS:
• ClearFrame License Plate Cover
• Stainless Steel Universal Fastener Kit
• Click and Stay™ Screw Caps
CARE INSTRUCTIONS:
• Clean with soapy water or window cleaner
• Do not use abrasive pads, harsh detergents
or degreasers on the ClearFrame
High Quality Stainless Steel Universal Fastener Kit*
Some vehicle
* models may require
re-use of existing fasteners
FITS THESE MODELS AND MORE:
Acura, AM General, Audi, BMW, Buick, Cadillac, Chevrolet, Chrysler, GMC, Daewoo, Dodge (except Viper), Ferrari, Ford, Honda, Hummer, Hyundai, Isuzu, Infiniti, Jaguar, Jeep, Kia, Land Rover, Lexus, Lincoln, Mazda, Mercedes­Benz®, Mitsubishi, Nissan, Oldsmobile, Pontiac, Porsche®, Range Rover, Saab, Saturn, Scion, Subaru, Suzuki, Toyota, Volkswagen, Volvo
For joining cover
& plate without mounting holes
PLEASE CHECK STATE AND LOCAL LAWS PRIOR TO USE.
Proudly Designed, Engineered, and Manufactured in the USA.
© 2014 by MacNeil IP LLC
Specialist In Original Equipment and Aftermarket Automotive Accessories
Loading...