ASSEMBLY AND INSTALLATION INSTRUCTIONS
Accessory Crossmember - Model 1060
5/16-18 x 2"
Hex Head Bolt
5/16" Flat
Washer
IMPORTANT
BEFORE YOU BEGIN
Read these instructions and
warnings completely before
installation.
BOLT KIT
Bolt Kit #32-1060 is provided with
your crossmember. Check this bolt
kit to be sure the following parts
are included:
Quan. Description
2 5/16-18 x 2" Hex Bolt
2 5/16-18 Nylon Lock Nut
4 5/16" Flat Washer
1 3/8-16 x 3/4" Bolt, Thread
cutting
PARTS LIST
1- Crossmember with end clamp
1- Socket End
Crossmember
3/8-16 x 3/4" Thread
Cutting Bolt
5/16-18 Nylon
Lock Nut
This product is only intended for, and only safe for, transporting
ladders, lumber, pipe and other similar materials. It is the responsibility of the user to secure these materials to the rack before
transporting. Any modifications made to this product, or use of
this product for any other purpose than its intended use, could
create a hazardous condition that can cause serious personal
injury or property damage.
TOOLS REQUIRED
1/2" Open or Box End Wrench (2)
5/8" Open or Box End Wrench
ASSEMBLY INSTRUCTIONS
1. Measure the outside distance between your ladder rack top rails where
you plan to use this accessory.
If the distance measures less
than 53-1/2", cut the end of
the Crossmember to fit.
Socket
5/16-18 Nylon
Lock Nut
WARNING
2. Insert the crossmember into the
Socket and with the open ends of
the clamps facing down, put in position
on the ladder rack.
3. Install fasteners and tighten, tightening the Thread Cutting Bolt last.
Rev. D 1/05 Part No. 24-1060
5/16-18 x 2"
Hex Head Bolt
5/16" Flat
Washer
-NOTICE-
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
If you have any questions, please give us a call. Call Toll Free 1-800-456-7865
WEATHER GUARD® products are protected by one or more of the following patents or trademarks:
U.S. - 842268, 1661625, 1663369; Canada - 282725; U.K. - 1400720; other patents pending.
KNAACK MANUFACTURING COMPANY
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, 60014 - 815-459-6020
©Knaack Manufacturing Co. 2005