Camel Toe MkII
instruction manual
WHE-209
SPECIFICATIONS
RHINO
INPUT IMPEDANCE.........> 400 kΩ
OUTPUT IMPEDANCE.......< 100 Ω
NOISE FLOOR...................-98 dBV
NOISE FLOOR
(
Classic
)...
-
100 dBV
BYPASS................................................................……..Relay True Bypass
DIMENSIONS......................................................4-25/32" x 3-3/16" x 1-3/4"
WEIGHT..................................................................………...................13oz
CURRENT DRAW.............................................................................110 mA
ENGAGED........................................................................................110 mA
BYPASSED......................................................................................22.8 mA
POWER SUPPLY......................................................................... 9 volts DC
All measurements made with controls at center.
Noise measurements are A-weighted.
POWER
The Camel Toe™ Overdri ve MkII is powe red by a single 9-volt battery,
a 9-vol t AC adapter s uch as the Dunlop ECB0 03/ECB003 EU, or t he
DC Brick
™
and Iso-Brick™ pow er s u pp lie s. Th e power i npu t is a
5.5mm x 2.1mm jac k with the posit ive voltag e on the oute r sle eve.
Using an external power supply will disconnect the battery.
Disconnect the inp ut jac k to preser ve ba tte ry life when not in use.
The pe dal will lock into bypa ss mode when it is t ime to c hange the
ba t t ery. I t als o i ncl u d es po wer p r ote c t ion c i rcu i t r y to pr e ve n t
damage from AC power supplies.
92503020548REVA
LLAMA
INPUT IMPEDANCE............100 kΩ
OUTPUT IMPEDANCE...….< 10 kΩ
NOISE FLOOR....…........…-85 dBV
TONE
DRIVE SELECT BYPASS
HI CUT
TRIPLE OVERDRIVE MKII
series
classic
RHINO LLAMA
VOLUME
DRIVE
VOLUME
DRIVE
OUT IN
+9VDC
Way Huge devotees rejoice! The legendar y Camel Toe
Triple Overdrive is back to expectorate its wonderfully
wild gritty tones all over your guitar signal. The Mark II
he rds t h e Gre en Rhi no Overd rive and th e Red L lam a
Ove r d ri v e t o g eth e r i nto a s i n gle r o w d y st a b le of a
stompbox. The Green Rhino section has all the controls
of its Mark IV iteration, while the Red Llama section gets
an all-new Hi-Cut control to go with Volume and Drive.
Use the Drive Selector footswitch to toggle bet ween the
two circuits, or flip the Series switch for a whole ’nother
soun d : t h e G re e n R h i no OD an d t h e R e d Llam a O D
combined in series. In Series mode, the Drive Selector
switch toggles the Red Llama OD on/off while the Green
Rhin o OD is always a ctive. Th e Camel Toe Triple Ove rdrive
MkII is an untamed beast! Handle with caution.
FOOTSWITCH - toggles
the effect on
/
bypass (blue LED
indicates effect is ON)
100Hz -
Governs the
amount of
thump in your
Rhino stomp,
+/
– 12dB
UNBRIDLED
OVERDRIVE!
CLASSIC toggles classic
green rhino sound
on/off (up=on, makes
100hz & 500hz
controls ina ctive)
VOL UME - Regulates the
roar of the Rhino
D RI VE - AD J USTS
YOUR RHINO'S
HA I RI NES S
500Hz - ADJUSTS
THICKNESS OF YOUR LOWER
MID– SECTION, +/– 12D B
TONE Modifies the tone
from mellow
to bright
d ri ve – UNLEASHES GNARLY,
THUNDEROUS GRIT
volume –
CONTROLS THE LEVEL OF AMP-
DOMINATING OUTPUT
S ER IES -
CRASHES RHINO CIRCUIT
INTO LLAMA CIRCUIT
Hi CUT -
CUTS HIGH
FR EQ UENC IES
Loading...