Date of Purchase:__________ Date of Install:_________ Installed by:____________
NOTES:
Thank you for your purchase of a CT-1 Counter system. With proper installation and maintenance, this system will provide you with high quality water for years to come. All of Premier’s
water enhancement products are rigorously tested by independent laboratories for safety and
reliability . If you have any questions or concerns, please contact our customer service department at 1-800-752-5582 (outside USA 480-675-7995) or refer to our online troubleshooting
at www.wattspremier.com.
2
Page 4
Operational Parameters
Do not use with water that is microbiologically unsafe or of unknown quality, without
adequate disinfection before or after the system. Installation needs to comply with state and
local plumbing regulations.
1 single stage Counter top system
1 CT-1 Filter and Housing with faucet connector
1 Manual and Warranty Card
If any of the items are missing please contact Watts Premier prior to installing.
Tools Recommended For Installation
√ A pair of pliers may be required
Installation
Step A: Remove the faucet aerator by turning it counterclockwise, (as shown in Figure A).
To loosen (counter clockwise)
Step B: Check faucet aerator threads. If your faucet aerator threads are the same as the diverter valve,
screw the diverter directly on to your faucet. (See gure below). If the aerator threads are different than the
diverter valve, the universal adapter will be required. (See gure on next page). If necessary, screw in the
universal adapter into the faucet.
3
Page 5
Step C: Now that you have connected your CT-1 to the faucet you need to purge the air from
the system. Turn on the cold water. Pull out the diverter control button and water will run
through the CT-1. (See gure C). Note: You may hear some noise as air is being purged
from the CT-1 and the rst few glasses of water through the unit may be dark color due
to carbon nes. Run water through your unit until it is clear of carbon nes.
Your CT-1 is now ready to provide you with fresh, clean drinking water.
FILTER CHANGE
Watts Premier recommends changing the filter
element at least every 6 months or 1350 gallons
(5100 liters).
Use Watts Premier’s replacement cartridges
only. Other lters may look the same, but only lters
by Watts are manfactured to t your CT-1 lter
unit in order to ensure proper reduction of water
contaminants.
Note: There will be water in the CT-1 Filter
Housing. To prevent spillage, turn the CT-1 upside
down before removing Filter Housing from the
base. See gure D.
Step 1: Remove CT-1 lter housing from base by
unscrewing it in a counterclockwise direction as
shown in gure D.
Step 2: Slide out used Carbon Block and filter
cartridge gaskets and discard. NOTE: Do not
discard the CT-1 lter housing O-Ring.
Step 3: Clean inside the of the CT-1 lter housing with warm
soapy water. Rinse the CT-1 Housing with warm clean water
to remove soap.
(Counterclockwise)
To tighten
(Clockwise)
FIGURE D
To Loosen
Step 4: Lubricate lter housing O-Ring with a water-soluble
lubricant (i.e. K-Y Jelly ® or Silicone lubricant) NOTE: Do not use Petroleum based lubricant (i.e. Vaseline ®).
Step 5: Seat O-Ring into lter housing grove.
Step 6: Slide new lter cartridge into lter housing and screw CT-Filter housing onto base.
Step 7: Repeat Step C (From initial instalation)
For replacement lters or questions regarding installation or servicing, contact:
Watts Premier Customer Service Department (toll free within the United States) 1-800-752-5582. (Outside the
United States) 480-675-7995. M-F: 8:00AM – 5:00PM MST. Replacement lters are also available online at:
Performance Data Sheet for specic claims to NSF Std-53.
CT-1
GENERAL USE CONDITIONS:
1: System to be used with municipal or well water sources treated and tested on regular basis to insure
bacteriological safe quality. DO NOT use with water that is microbiologically unsafe or unknown quality
without adequate disinfection before and after the system. Systems certied for cyst reduction may be used on
disinfected water that may contain lterable cysts.
2: Operating Temperature: Maximum 100o F (40.5o C) Minimum 40o F (4.4o C)
3: Operating Water Pressure: Maximum 100-psi (7.43 kg/cm2) Minimum 10-psi
4: Turbidity: < 5 NTU
5: pH: 5 to 10
6: Maximum ow Rate: 0.50 gpm (1.89 lpm)
RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVAL:
Note: Depending on incoming feed water conditions replacement time frame may vary.
Description Units Change time Frame
1 Micron Carbonblock P-CB-1: CT-1 6 Months or 1350 gallons
6
Page 8
8716 W Ludlow Drive Suite #1 • Peoria, AZ 85381
Limited Warranty
What your Warranty Covers:
If any part of your WATTS PREMIER CT-1 System is defective in workmanship (excluding replaceable lters), return unit
after obtaining a return authorization (see below), within 1 year of original retail purchase, WATTS PREMIER will repair or,
at WATTS PREMIER’S option, replace the system at no charge.
How to obtain Warranty Service:
For warranty service, call 1-800-752-5582 for a return authorization number. Then, ship your unit to our factory, freight and
insurance prepaid, with proof of date of original purchase. Please include a note stating the problem. Premier will repair it,
or replace it, and ship it back to you prepaid.
What this warranty does not cover:
This warranty does not cover defects resulting from improper installation, (contrary to WATTS PREMIER’S printed
instructions), from abuse, misuse, misapplication, improper maintenance, neglect, alteration, accidents, casualties, re,
ood, freezing, environmental factors, water pressure spikes or other such acts of God.
This warranty will be void if defects occur due to failure to observe the following conditions:
1. The Counter Top System must be hooked up to a potable municipal or well cold water supply.
2. The pH of the water must not be lower than 5 or higher than 10.
3. The incoming water pressure must be between 10 and 100 pounds per square inch.
4. Incoming water to the Counter Top cannot exceed 100 degrees F (40 degrees C.)
5. Do not use with water that is micro-biologically unsafe or of unknown quality without adequate
disinfection before or after the system.
This warranty does not cover any equipment that is relocated from the site of its original installation.
This warranty does not cover any equipment that is installed or used outside the United States of America and Canada.
LIMITATIONS AND EXCLUSIONS:
WATTS PREMIER WILL NOT BE RESPONSIBLE FOR ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTIBILITY
AND FITNESS FOR A PARTICULAR PURPOSE. WATTS PREMIER WILL NOT BE RESPONSIBLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING TRAVEL EXPENSE, TELEPHONE CHARGES, LOSS OF REVENUE, LOSS OF TIME,
INCONVENIENCE, LOSS OF USE OF THE EQUIPMENT, AND DAMAGE CAUSED BY THIS EQUIPMENT AND ITS FAILURE TO
FUNCTION PROPERLY. THIS WARRANTY SETS FORTH ALL OF PREMIER’S RESPONSIBILITIES REGARDING THIS EQUIPMENT.
OTHER CONDITIONS:
If WATTS PREMIER chooses to replace the equipment, WATTS PREMIER may replace it with reconditioned equipment. Parts used in
repairing or replacing the equipment will be warranted for 90 days from the date the equipment is returned to you or for the remainder of
the original warranty period, whichever is longer. This warranty is not assignable or transferable.
YOUR RIGHTS UNDER STATE LAW:
Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitations or exclusions may not apply.
and you may have other legal rights which vary from state to state.
This warranty gives you specic legal rights,
7
Page 9
Watts Premier, Inc. 8716 W Ludlow Drive Suite #1 Peoria, AZ 85381
Phone: 800-752-5582 www.wattspremier.com Fax: 623-866-5666
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.