IS-RL 600
Instructions for Installing Flippen RL 600
Automatic Livestock Watering Kit
Assembly and Reordering Instructions
To Reorder
PART PART NO. ORDERING CODE NO.
Complete Assembly RL 600 0780105
Universal Tank Adaptor (Not shown) UA600 0780245
Arm and Seat RL 600A 0780173
Nuzzle and Arm Assembly RL 600V 0780174
Stem and Chain Assembly RL 600 SC 0780365
Garden Hose Adaptor (Not shown) AP-112 0780242
Parts and Installation Instructions
Parts Included with Kit:
Plastic Valve Assembly
Brass Valve Arm
Thumbscrew
Stem/Chain Assembly
6" Float Ball
RL 600
Parts Not Included with Kit:
Teflon® Sealing Tape
AP-112 Garden Hose Connector (if connecting to a garden hose)
Installation Instructions:
1. Remove bulkhead fitting from tank, reverse so drain plug
faces into tank, and reinstall.
2. Remove drain plug from bulkhead fitting and install valve
assembly. Hand tighten.
3. Attach brass valve arm to plastic valve arm with thumbscrew
provided. Make sure serrations mesh properly.
4. Attach threaded end of stem to the brass valve arm.
5. Attach float ball to threaded screw at end of chain. The float
is self tapping.
6. Using Teflon tape to seal threads, connect 1/2" tapered pipe
supply line to inlet side of valve. Do not use pipe dope or solvent cement. Use an AP-112 fitting for garden hose connection.
7. Adjust float level to desired height by changing angle of brass
arm.
8. Maximum pressure - 75 psi.
9. Maximum temperature - 140°F
Limited Warranty: Watts Regulator Co. (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of
original shipment. In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER
WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special
or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting
from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no
control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above
limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to
determine your rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.
A Watts Water Technologies Company
USA: Tel. (978) 688-1811 • Fax: (978) 794-1848 • www.watts.com
Canada: Tel. (905) 332-4090 • Fax: (905) 332-7068 • www.watts.ca
IS-RL 600 1233 EDP# 1915222 © 2012 Watts