Watts 500221 User Manual

INSTALLATION, OPERATION AND MAINTENANCE MANUAL

Warning

Please read carefully before proceeding with installation. Your failure to follow any attached instructions

or operating parameters may lead to the product’s failure.

Save manual for future reference

Whole House Filtration

Model: 500221

Watts Premier • 8716 West Ludlow Drive • Peoria AZ • 85381

1-800-752-5582 • www.premierH2o.com

Rev. Date 04/08/2011 Manual # 199031

Watts Premier’s Whole House Filtration with pressure relieve valve

Watts Premier’s Whole House Filtration system should be installed on the main cold water line servicing the house and installed in location that is protected of the environment. Watts Premier does not take any responsibility for the plumbing of the system into the water line. Install accordingly to your local plumbing codes.

Watts Premier’s Whole House Filtration system comes with one inch ttings. If your water line is smaller than one inch you will need to use proper reducers for the installation (not included).

Note: Only Teon tape should be used on threaded ttings, do not use pipe dope as it may cause damage to the plastic threads.

Operational Parameters:

1. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

2. Operating Temperatures: Maximum 100F (37.8C) Minimum 40F (04.4C)

3. Operating Pressures:

Maximum 85 PSIG (5.95 kg/cm2) Minimum 5 PSIG (0.35 kg/cm2)

4. Maximum Flow Rate: 22 GPM @ 60 psig

83.27 LPM @ 4.20 kg/cm2

Installation Tools & Materials Recommended:

For Typical Installation:

- Pipe Cutter or Hack Saw

- 1/2” Open-end Wrench & Adjustable Pipe Wrench

- Variable Speed Drill

- Teon Tape (Supplied)

+ 4 hidden pages