Wattbox Wb-ups-nmc User Manual
™
Quick Start Guide
WB-UPS-NMC
The WattBox network management card gives you internet control over your
WattBox non-IP UPS products.
ANATOMY
Ethernet port (to network)
Ethernet port (to UPS)
Ethernet port status LEDs
Pin Jumper
PORT STATUS LED KEY
Green LED (Ethernet bandwidth)
On: Port is operating at 100Mbps
Off: Current web bandwidth is 10Mbps
Yellow LED (link status)
Flash: Link Active
Off: Card is not connected to the network
INSTALLATION
CAUTION: This card is not UL certied.
Be sure to ground yourself before
installation, and only handle the card by
its face plate!
1. Remove the cover from the
Intelligent Slot on the back of your
UPS. Save the screws for securing
the SNMP card.
2. Align the edges of the network
card with the guide channels on
the inside of the Intelligent Slot
as shown. Carefully slide the card
all the way in until the faceplate is
snug against the UPS. Secure it
with the screws.
3. Plug the network cable to the Ethernet port.
RESETTING WITH THE PIN JUMPER
While the jumper connects pins 1 and 2, the SNMP card functions normally.
Moving the jumper to connect pins 2 and 3 resets the SNMP card to its default
setting: IP address 192.168.102.230 and password 12345678. After resetting the
SNMP card, be sure to move the jumper back to connects pins 1 and 2.
Loading...