WateRx WX325 User Manual

g

y

The WateRx 325 system

combines three separate

media technologies-

ceramic, carbon, and
specialized ion-exchange
resin to give you a clean,

delicious water for

drinking and cooking.

Ceramic filtration has been the international standard for bacteria and cyst
removal for over 100 years. WateRx cleanable ceramic cartridge forms a
mechanical barrier, which removes 99.999% of bacteria, lead, and other
particulates below one half micron.

Carbon filtration removes up to 99.9% of most organic chemicals
(herbicides, pesticides, etc), or

anic lead, chlorine, and THM’s. WateRx uses
the highest grade of bituminous carbon available to insure maximum
performance against off-tastes, odors, colors, and potentially harmful
chemicals.

Specialty resin filtration removes high percentages of inorganic lead and
other heav

metals, which can cause fetal and infant brain damage, as well as

adult heart disease.

Lifetime- warranted manifold system insures consumer satisfaction.

Sleek long-reach chrome faucet matches all décor. (Color and Deluxe faucets
available.)

Longlife cartridges are good for 3,000 gallons.

WateRx Corporation
6761 Bramble Avenue
Cincinnati, OH 45227

Visit our website at: www.waterx.com

Email us at : [e-mail]

Customer Service: 1-800-548-5785

Fax: [phone]

W

ateRx Advantages

 No more heavy bottles of water to carry
 Clean w
 Cleanable ceramic cartridge
 Special resin cartridge for maximum lead reduction
 Highest grade carbon ca
 Filter only w
 Plumb to icemaker, w
 Healthful minerals and fluoride remain in your w
 Easy-touch faucet provides unlimited w
 No electricity, w

 Can be used to filter well and cistern water

ater for pennies a gallon

rtridge for great taste

ater for drinking and cooking

ater-chiller, or hot-water dispenser

ater

ater

ater waste, or holding tank

Removes 99.999%

 Bacteria
 Cysts (giardia)
 Cryptosporidium
 Chlorine and THM’s
 Rust and sediment
 Bad tastes, odors, and color
 Asbestos fibers
 Inorganic particulate and organic lead

 Organic chemicals such as herbicides, pesticides, and solvents

Installing Your WX 100 & 325 Series

Never hook the system to the hot water line­ONLY THE COLD

Units Cartridges

WX 100 WXC01
WX 110 WXC11
WX 125 WXC11
WX325 WXC33

WX 100 inlet- off center
“ Outlet- center fitting
WX 325 inlet- rear fitting
“ outlet- front fitting

Mounting the WateRx system: Measure the housing clearance (3 or more inches) and
affix the manifold to the wall of the undersink cabinet with drywall screws. The bracket
for the 100 series should go around the white sump, just below the upward curve.
Remove all packing materials from

Take the cartridge/s and push them up into the head/manifold. In the WX325, the
carbon cartridge is the blue tube with black
caps.

the housing and cartridge inside.

caps- the resin is the blue tube with white

Turn off the cold water at the valve under the sink or nearest shut-off valve. Connect the
black tubing(inlet) to the water line or saddle valve (provided with the WX 125 & WX325
unit). Connect the clear tube(outlet) to the faucet or refrigerator connection. Note- DO NOT
turn inlet/outlet fittings on the head or manifold- these are sealed at the factory.

Activate the system and check for proper sealing at fittings. Turn your cold water
valve back on once the system is assembled. Flush the system by running atleast 5
gallons of water through it. Look for gray carbon dusting initially. This
is harmless and will subside when the carbon has reached is proper absorption rate.
The dusting should go
check the seals.

away in a few days. Shut off the faucet after flushing and

carbon dusting

Replacing the cartridge/s: Shut off the water valve nearest to the unit. Flip up the little
black handle on the faucet as if the water is continually running. This action releases the
pressure on the housing and allows you to unthread the white sump from the head/manifold.
Remove cartridge/s and insert the new cartridges by pushing them up into the
head/manifold. Cover the new cartridges with the white sump/s and thread them onto the
black head/manifold. Turn your water back on.

Make sure to replace your cartridges annually.