Waterstone 4400, 4410 User Manual

WATERSTONE

Diverter replacement

4400, 4410 Gantry

® series faucets.

41180 Raintree Court // Murrieta, CA 92562 // 1-888-304-0660

Diverter Replacement
4400, 4410 Gantry Series Faucets

a

b

c

Diverter

c

Diverter

1- Turn off water supply to faucet.

2- Unscrew retainer nut (a) until disengaged from thread.

Note: The diverter may be located on either side or in front or back.

3- Carefully swivel the spout assembly (b) back and forth while
lifting up just until the retaining screw (c) is accessible with a
screw driver, this will allow the assembly to “rest” without putting
pressure on the faucet’s finish.

4- Remove the diverter retaining screw (c).
Using a needle nose pliers or small hook, remove the old diverter
by pulling it straight out.

5- Insert the new diverter by pushing straight in (use a little liquid
soap to lubricate the o-rings before installation), make sure the
set of 6 ”half-holes” are pointing out.

6- Re-install the retainer screw (c). Swivel the spout assembly
back down and tighten the retaining nut by hand.

7- Check for leaks and proper operation of the spray.

MADE IN THE USAwww.waterstoneco.com