Waterpik Technologies WP-65, WP-70, WP-60 User Manual

Insert

OFF

QUICK START GUIDE

Model WP-60/65/70

Prepare the Reservoir:

1

Fill

Replace the
reservoir onto the base,

PRESSING DOWN FIRMLY

to ensure full seating.

Prime Unit (First Time Use Only):

3

Prior to Very First Use of Unit, Prime Unit:

Set pressure control slide switch on handle
to high, point the handle and tip into sink.
Turn unit ON until water flows from the handle,
turn unit OFF.

Remove the reservoir
from base and fill with
lukewarm water.

Replace

High

Select and Insert Tip:

2

No

Gap

Press tip firmly into
handle. When tip is
properly inserted there
should be no gap between
control knob and tip. To
remove tip, simultaneously
hold control knob down
and lift tip up.

Adjust Pressure and Pause Control:

4

For first time
users, adjust

pressure control
to lowest position.
Gradually increase
pressure as you
prefer.

You can temporarily stop
water flow by pressing
the pause button on the
handle.

PAUSE

Low

continued

on back

OFF

Using your Waterpik

5

Always place tip in mouth
before turning unit on.

Lean over sink and close lips
enough to prevent splashing,
while still allowing water to flow
from mouth into the sink.
Turn unit ON.

ON

Technique Tips for Best Results:

6

Aim the tip just above the gum line
at a 90 degree angle.

Starting with the back teeth, follow the
gumline and pause briefly between teeth.

Continue until all areas around and
between teeth have been cleaned.

®

Water Flosser:

PAUSE

Always PAUSE or
turn unit OFF before
removing tip from
mouth. When finished
empty any excess
water from reservoir.

7

REGISTER YOUR

PRODUCT

ONLINE NOW!

Receive up to

$

44

in savings.

www.waterpik.com/register

Water Pik, Inc.

1730 East Prospect Road, Fort Collins, CO 80553-0001 USA

1.800.525.2774 • www.waterpik.com

©2009 Water Pik, Inc.

20012884-F AA