Waterpik Technologies WP-100 User Manual

Prepare the Reservoir:
1
2
Insert Tip:
Quick Start
G
UIDE
Fill
Replace the reservoir onto the base, pressing down
firmly to ensure full seating.
Adjust Water Pressure:
3 4
For first time use, adjust the pressure dial on the base to
lowest position.
Gradually increase pressure as you prefer.
Remove the reservoir from base and fill with lukewarm water.
Replace
LOW
Select the appropriate tip and insert into the handle. Press firmly until the tip clicks into place.
Caution: Do not press tip eject button while unit is running.
Pause Button Control:
PAUSE
Insert
You can temporarily stop water flow by pressing the pause button on the handle.
continued on back
OFF
OFF
ON
On/Off Procedure:
5
Always place tip in mouth before turning unit on.
Lean over sink and close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink. Turn unit ON.
PAUSE
Always PAUSE or turn unit OFF before removing tip from mouth.
Technique Tips for Best Results: When finished:
6
Aim the tip just above the gum line at a 90 degree angle.
Starting with the back teeth, follow the gum line and pause briefly between teeth.
Continue until all areas around and between teeth have been cleaned.
Water Pik, Inc.
1730 East Prospect Road, Fort Collins, CO 80553-0001 USA
1.800.525.2774
7
Turn the unit OFF and empty any liquid left in the reservoir.
www.waterpik.com
For more details refer to the instruction booklet.
Empty
FN 20011332-F AA
Loading...