Waterpik WP-260 User Manual

QUICK START GUIDE

I

1

2

3

O

I

1

2

3

O

NO
Gap

1

2

3

I

O

Model WP-260

Prepare the Reservoir:

1

Remove the reservoir from

Fill

base and fill with lukewarm
water.

Select and Insert Tip:

2

Press tip
firmly into
handle.

Replace

Insert

Replace the reservoir onto the
base, PRESSING DOWN FIRMLY
to ensure full seating.

Prime Unit (First Time Use Only):

3

Prior to Very First Use of Unit, Prime
Unit:

Set pressure control dial on base to

high, point the handle and tip into sink.

Turn unit ON until water flows from the
tip. Turn unit OFF.

High

This device is compatible with global voltages of 100 - 240VAC, 60/50Hz.

Adjust Pressure Control:

4

For first time users, adjust pressure
control to lowest position. Gradually
increase pressure to your liking.

Low

When tip is properly
inserted there should be
no gap between handle
and colored tip ring.

O

2

1

3

continued on back

On

1

2

3

I

O

Using your Waterpik® Water Flosser:

Remove

5

Always place tip in mouth
before turning unit on.

Lean over sink and close lips enough
to prevent splashing, while still
allowing water to flow from mouth
into the sink. Turn unit ON.

Aim the water stream just above the
gumline at a 90 degree angle.

O

2

1

3

Tip Removal:

6

Slide the tip eject button up
on the handle. Remove the tip.

Caution: Do not slide tip eject
button while unit is running.

Tip

Eject

Up

Water Pik, Inc.

1730 East Prospect Road, Fort Collins, CO 80553-0001 USA ©2011 Water Pik, Inc.

1.800.525.2774 • www.waterpik.com

Starting with the back teeth, follow
the gumline and pause briefly
between teeth.

Continue until all areas around and
between teeth have been cleaned.
Turn unit OFF.

7

REGISTER YOUR

PRODUCT

ONLINE NOW!

Receive up to

$

44

in savings on the purchase of

®

additional Waterpik

products.

www.waterpik.com/registration

FN 20013604-F AB