Water Inc LVH1200 User Manual

MODEL: LVH1200

SUPPLEMENTAL INSTRUCTIONS

NOTE: THESE INSTRUCTIONS SUPERSEDE EVERHOT
INSTALLATION INSTRUCTION SHEET (WHERE NOTED).

#3 Place o-ring (provided) onto faucet tubes and into groove at
underside of faucet body. Use the provided o-ring only. Do not use
plumbers putty!

#4 From undersink install mounting plate [drawing], flat washer
[drawing], and special nut [drawing] onto 5/16” neoprene tube. Tighten nut
until mounting plate almost touches underside of mounting surface.

#5 Adjust faucet to desired position. Spout may be positioned
independent of faucet body. From undersink, tighten the special nut. Note
that after nut is tightened, spout cannot be adjusted or swiveled.

#10 Connect neoprene tube from faucet to top center outlet tube on the
heating tank using 3/8” x 5/16” push-to-connect check valve/reducing union
(provided). This fitting must be used; do not substitute another fitting.
Excess tubing may be trimmed if desired, but leave 2” to 3” of slack in the
tube. Avoid any sharp bends. Be sure tube end is cut squarely, and insert
end of tube into reducing union.

#11 Follow this step as stated on EverHot Instruction sheet except turn on
faucet hot lever by pulling it forward until it locks on.

The Everhot mark is used under license from Bradford White Corp.

F:instruct/warehouse/lvh1200 supplemental install instruct.doc (rev 4/13/2010)