Water Inc LVH1120H User Manual

1044 East Del Amo Blvd • Carson, CA 90746 • 310.885.4400 • 800.322.WATER(9283)

Fax [phone] • Order Desk Fax [phone]

waterinc.com

EVERHOT®!

LVH720H/LVH1120H

HOT ONLY

SUPPLEMENTAL INSTALLATION INSTRUCTIONS

(See red colored numbers on installation instructions

and modify as noted below)

Note: If you have any questions regarding these instructions, call
our Service Department at 800-322-9283 extensions 112 or 115
BEFORE proceeding with the installation.

# 1 Clear is changed to tan santoprene tube

# 2 Parts list has changed as follows:

One Faucet, one EverHot Tank Assembly, one 3/8" x
5/16" Quick-Connect Reducing Union, one escutcheon
with o-ring, one metal special washer, one piece
santoprene tube with clamp.

# 3 Insert O-ring into groove in escutcheon, and place onto

faucet tubes. Install faucet assembly into mounting
hole.

# 4 Number 4 is changed as follows:

Install metal special washer onto faucet shank. Install
nut onto shank and tighten. Install santoprene tube
onto end of shank at least ½”. Apply clamp to top of
tube and squeeze until tight.

# 5 Before final tightening of the washers as discussed in

#4, be sure you have positioned faucet spout in the
desired direction.

# 6 Ignore “FIG. 1"

# 7 Number 7 is changed as follows:

*To fill hot tank, rotate hot side handle forward and let
run until water flows out of the spout. (Note red dot or
red and blue dots near faucet bottom to identify hot
and cold side of faucet) *

* Failure to follow this step will cause permanent damage
to the heating tank. Tank must be filled with water prior to
plugging in the power cord. “Dry start” damage to the

heating tank is not covered by the product warranty.

The Everhot® mark is used under license from Bradford White Corp.

f:instruct/warehouse/LVH720H LVH1120H HOT supplemental install instruct.doc (revised 6/5/2013)

!