Water Filters Australia WFA HIFLOW Owner's Manual

Thank you for purchasing

a Water Filters Australia

HiFlow commercial grade

half micron In-Line Water Filtration System.

With your WFA HiFlow In-Line

system, you get premium quality filtered water

direct from your cold water tap that’s clean,

great tasting, healthy and convenient for you

and your family.

Model No.

WFA-HiFlow

Owners Manual

T [phone] F [phone]
E [e-mail] W www.hiflowfilter.com.au

Water Filters Australia Pty Limited

Unit 11, 26 Wattle Road BROOKVALE NSW 2100 Australia

PO Box 636 FRESHWATER NSW 2096 Australia

ABN: 78089 574 489

Check for compliance with state and local laws and regulations. Product performance

is dependant upon incoming water conditions. This drinking water system must be maintained

according to the manufacturer’s instructions, including replacement of cartridge.

AS3497

Lic.WMKA22045

IAPMO R&T OCEANA

This appliance meets the domestic water treatment
appliance Standards AS/NZS3497 for the following
water treatment processes:

CLASS TREATMENT TYPE FUNCTION PASS
___________________________________________________________________________________

I. Microbiological Status Will stop bacteria increasing but will N/A
Bacteriostatic not stop them unless IIa is passed.
___________________________________________________________________________________
II. II (a) Microbiological Treatment Will remove or inactivate bacteria. N/A
Bacteria Removal
___________________________________________________________________________________
II (b) Virus Removal Will remove or inactivate virus. N/A
___________________________________________________________________________________
III (c) Protozoa Removal Will remove or inactivate Cryptosporidium
and Guardia.Will not remove or inactivate
bacteria and virus unless II(a) and II(b) is passed.
__________________________________________________________________________________
III. Turbidity and Particulate Reduces Cloudiness
Reduction
___________________________________________________________________________________
IV. Taste and Odour Reduction Reduces Tastes and Odours
___________________________________________________________________________________
V. Chemical Treatment Decreases carbon chemicals
Lead pH 6.5, Lead pH 8.5 and Chlorine

WaterMark

TM









WARNING: FOR CORRECT OPERATION OF THIS

APPLIANCE IT IS ESSENTIAL TO OBSERVE

THE MANUFACTURER’S INSTRUCTIONS.

www.hiflowfilter.com.au

email: [e-mail]

OPERATING SPECIFICATIONS:

• Capacity: 11,355 litres

• Pressure Requirement: 10-125 psi (0.7 - 8.6 bar), non-shock.

• Temperature: 2-38

O

C

• Flow Rate: 8.3 litres per minute.

GENERAL INSTALLATION / OPERATION/MAINTENANCE
REQUIREMENTS:

• Space required: 51cm x 13cm including 6cm of clear space for cartidge change.

• Install vertically or horizontally with stabilizing support bracket

• Flush new cartridge at full flow for 3 to 5 minutes until air is purged.

• Replace cartridges when capacity is reached, or when flow becomes too slow,
but at least annually.

SPECIAL NOTICES:

• Installation instructions, parts and service availability, and standard warranty
are included with the product when shipped.

• This drinking water system must be maintained according to manufacturer’s
instructions, including replacement of filter cartridges.

• Do not use w

ith water that is microbiologically unsafe,

or of unknown quality

without adequate disinfection before or after the system.

Systems certified for

cyst reduction may be used on disinfected waters that may contain filterable cysts.

• The contaminants or other substances removed or reduced by the water treatment
system are not necessarily in your water.

• Check for compliance with state and local laws and regulations.

• Tested under sustained standard laboratory conditions, actual performance may vary.

In�Line Mains Water Filter System

WFA HIFLOW INLINE MAINS WATER FILTER SYSTEM

Model No. WFA HIFLOW
Important Notice:

Read this performance data sheet and compare the capabilities of this

unit with your actual water treatment needs.

FEATURES:

• Finely polishes treated water to premium quality for drinking and cooking.

• Reduces chlorine taste and odour.

• Reduces dirt, rust, asbestos fibres and other particulates such as oxidized iron,
manganese, and sulphides.

• Reduces parasitic protozoan cysts such as Giardia, Entamoeba and

Cryptosporidium.

• Absorbs common earthy, mouldy, fishy tastes and odours.

• Reduces limescale build up in water using appliances.

HEALTH CLAIM PERFORMANCE CLASSIFIED BY UL.
This system has been tested according to NSF/ANSI 42 and 53
for the reduction of the substances listed below

The concentration of the indicated substances in water entering the system was
reduced to a concentration less than or equal to the permissable limit for water
leaving the system, as specified in NSF/ANSI 42 and 53

Influent Challenge
Concentration

2.0 mg/L + 10%

at least 10,000
particles/mL

Minimum 50,000/L

0.15 mg/L + 10%

0.15 mg/L + 10%

11+ 1 NTU

†

Max. Permissible
Product Water
Concentration

0.010 mg/L

0.010 mg/L

0.5 NTU 1

Reduction
Requirements

>50%

> 85%

99.95%

Minimum
Reduction

99.99%

94.1%

98.9%

98%

Average
Requirements

98%

99.8%

99.99%

97.2%

98.9%

99%

Substance

Standard 42 - Aesthetic Effects

Chlorine

Particulate
Class 1 particles

0.5 to < 1 um

Standard 53 - Health Effects

Cyst

Lead 8.5

Lead 6.5

Turbidity

_________________________________________________________________________________________________________________________

†

NTU= Nephelometric Turbidity Units.

Performance
Data