Waterfall Audio Niagara Platinum User Manual

Warning :

Always unpack your speakers with somebody’s help. Unpack as shown on the photos hereunder. To repack, reverse the procedure.
Always keep your original packaging, always store flat, if you use a carier always ship on pallet. This document is to be included in any
resale of the product.

Any glass cleaner can be used, apply with a soft paper towel. Never use abrasive products.

Open the box as shown and remove
the glass horn box.

Remove the protection.

Person n°1 is positionned at the bottom of

the speaker, person n°2 at the top.
Pull out the speaker at the same speed.

Remove the foam protection
on the "top" of the speaker.
Start by the rear.

4) Cleaning :

3) Connection :

1

2

3

This product has been designed for indoor residential use only. This product is not intended to be placed in any area of
passage, including but not limited to walk ways and stairways. In addition Niagara speakers have been designed to be used
only on indoor flooring, and must not be affixed to walls, attached to ceilings, placed in enter-tainment centers or othe-
rwise used or placed in any location other than on the floor.Make sure your speakers are positioned on a perfectly flat
and level surface. Placing your speakers in a corner will enhance the low frequencies, and placing further off the wall will
enhance the sound image. However each room and configuration being different and unique, we advise you to test
different positions to achieve the best performance.

2) Positionning :

GLASS. FRAGILE : HANDLE & USE WITH CARE.

Unpacking

Unpacking and using this product means you have read & understood this warning

WARNING : GLASS. FRAGILE. HANDLE & USE WITH CARE :

• The floorstanding speaker you have purchased is made of GLASS PANELS.

• Any Impact on the product could potentially damage the product.

• There is a potential risk of injury to persons if the product is not used as instructed.

• In the event the speakers break, DO NOT

attempt to pick up the pieces of glass of the speaker

without first protecting your hands and using appropriate tools in collecting the pieces of the speaker.

• This product has been designed for indoor residential use only.

• This product is not intended to be placed in any area of passage, including but not limited to walk

ways and stairways.

• In addition Niagara speakers have been designed to be used only on indoor flooring, and must not

be affixed to walls, attached to ceilings, placed in entertainment centers or otherwise used or
placed in any location other than on the floor.
USE CAUTION WHEN UNPACKING, REPACKING, INSTALLING AND USING THE PRODUCT.

FRAGILE

FRAGILE

1) Unpacking / Repacking :

Please read this notice

before unpacking.

A minimum of 2 persons is requested

to unpack or repack each Speaker.

Make sure the cable is of the right section and specific to loudspeakers connection. Follow the polarities : + (red termi-
nal ), - (black terminal), for each speaker. Use the same length cable for both right and left speakers. Do not connect
your speakers directly to the mains.
We highly recommend the use of Waterfall
Audio Cable made up with a high quality
oxygen free copper, which you can purchase from your Waterfall dealer.

Always unpack your speakers with somebody's help

.

Floorstanding speakers

Niagara Platinium

User’s Manual

www.waterfallaudio.com

Made in France

5) Warranty :

See Waterfall Warranty Card

This document is to be included in any resale of the product.

+

Any glass cleaner can be used, apply with a soft paper towel. Never use abrasive products.

When the speaker is in place then position the glass horn
as shown.
Beware NOT TO HIT the Glass Horn onto the spea-
ker. Never try to move the speaker when the glas horn is
in place.

4) Cleaning :

3) Connection :

Remove the plastic
protection by hands.

NO TOOLS

Then place the speaker
in the listening position.

Do not connect the speaker
to the amplifier yet.

4

5

Connect the glass horn as shown.
Then connect the speakers to your amplifier.

Never plug your speakers into the main
supply.

6

This product has been designed for indoor residential use only. This product is not intended to be placed in any area of
passage, including but not limited to walk ways and stairways. In addition Niagara speakers have been designed to be used
only on indoor flooring, and must not be affixed to walls, attached to ceilings, placed in enter-tainment centers or othe­rwise used or placed in any location other than on the floor.Make sure your speakers are positioned on a perfectly flat
and level surface. Placing your speakers in a corner will enhance the low frequencies, and placing further off the wall will
enhance the sound image. However each room and configuration being different and unique, we advise you to test
different positions to achieve the best performance.

2) Positionning :

+

-

Make sure the cable is of the right section and specific to loudspeakers connection. Follow the polarities : + (red termi­nal ), - (black terminal), for each speaker. Use the same length cable for both right and left speakers. Do not connect
your speakers directly to the mains.
We highly recommend the use of Waterfall
Audio Cable made up with a high quality
oxygen free copper, which you can purchase from your Waterfall dealer.

All drivers are developed and manufactured by Atohm (France).

Unité de fabrication et bureaux : ZA Praderies, 83 570 Carcès - France - Tel : [phone] - Fax : [phone] - [e-mail]

www.waterfallaudio.com

5) Warranty :

See Waterfall Warranty Card

This document is to be included in any resale of the product.

1

2

3

FRAGILE

+

-