Water Creation VMI030CWMB38 Specifications
MODEL: F2-0013
TOOLS AND MATERIALS
LAVATORY FAUCET INSTALLATION GUIDE
BEFORE YOU BEGIN
1) Shut off water supply.
2) Carefully inspect waste and supply tubing for signs of damage.
3) Replace waste or supply tubing
ecessary
if n
A) SPOUT INSTALLATION
1) Remove washer, lock nut and connect tee.
2) Apply plumbers’ putty or sealant.
3) Locate mounting hole and insert spout into deck or lavatory.
4) Screw and tighten washers, lock nut onto the shank and secure the spout
5) Screw and tighten the connect tee to the shank.
6) Remove excessive plumbers’ putty or sealant
.
Basin Wrench
Pipe Wrench
Adjustable wrench
Screwdriver
Teflon Tape
Flexible Water
Supply Line
B) HANDLE VALVE INSTALLATION
1) Place lower plastic washer and lock nut over valve body.
2) Insert valve body from under the sink.
3) Place upper rubber washers and escutcheon on valve spindle.
4) Adjust position of valve body. Secure valve body with lock nut and escutcheon.
5) Place handle onto spindle.
6) Tighten handle with screw.
ESCUTCHEON
HANDLE
FLOW REGULATOR
METAL WASHER
LOCK NUT
CONNECT TEE
RUBBER WASHER
PLASTIC WASHER
LOCK NUT
VALVE BODY
C) FLEXIBLE HOSE INSTALLATION
1) Install flexible hoses onto hot and cold water outlets.
2) Secure hoses with wrench. Do not over tighten.
3) Connect flexible hoses to supply tee.
4) Circle the excessive part of hoses as shown in figure below.
END BODY OUTLET
MODEL: F2-0013
E) SUPPLY CONNECTION
1) Install lavatory according to manufacturer’s instructions.
2) Connect hoses (not provided) to angle stops.
3) Tighten all connections.
4) Flush out water for two minutes before connect hose to faucet valve.
(This act to avoid debris trapped the flow regulator)
*** VERY IMPORTANT ***
FLEX HOSE
D) DRAIN WASTE INSTALLATION
1) Disassemble the drain.
2) Apply plumbers’ putty or sealant to bottom side of flange.
(Or use attached rubber washer to instead of putty)
3) Insert drain body through sink.
4) Attach the gasket, Teflon washer and tighten the lock nut.
5) Apply Teflon tape to the drain pipe threads and screw with drain body.
6) Remove excessive plumbers’ putty or sealant
RUBBER WASHER
GASKET
TEFLON WASHER
LOCK NUT
SUPPLY TEE
.
STOPPER
DRAIN BODY
PIPE
F) INSTALLATION CHECKOUT
1) Ensure all connections are tightened properly.
2) Turn on main water supply.
3) Turn on and off cold and hot water respectively.
4) Turn on both hot and cold water and turn off. Check for leaks.
5) If necessary, remove the connect tee check for debris in flow regulator
and clean it.
6) Reinstall connect tee.
COMPLETE INSTALLATION
Loading...