Water Creation SL000305, SL000303, SL000301, SL000302 User Manual
MODEL: SL-0002 / SL-0003
Screwdriver
WATER SUPPLY LINE INSTALLATION GUIDE
Note:
Use Teflon tape on all threaded connecons
Measure twice cut once
A. Set adapter (1), washer (2) and locknut (3) through the tub with coupler.
(Note: These parts are faucet water inlets, not include with this supply kit )
B. Take the supply tube (5) and put washer (4) onto the upper end of the tube.
C. Slide the decorave nut (6) up to the top of the supply tube and over the
washer.
D. Slide the escutcheon (7) up the tube slightly, then, directly under the
Adjustable Wrench Teflon Tape
escutcheon, slide the locknut (8) up to the end of the tube.
E. Take the washer (9) and put it, with the wide end of the washer upward,
onto the boom end of tube.
F. Take the supply tube and aach the boom end of it to the water supply
tubing in your floor by screwing the locknut down ghtly. Set the
escutcheon to the floor.
G. Take the upper end of the supply tube and aach it to adapter. Tighten
the decorave locknut.
***WARNING***
DO NOT BEND BRASS TUBES
The faucet holes and
water main must be lined up
correctly. Attempting to
install by bending the tubes
may cause crack or leaks
Loading...